ELECTRIMART 65019 Manual

CONVECTION
SPACEHEATER
PLEASE READ AND SAVE THE INSTRUCTION MANUAL FOR FUTURE USE
This heater requires no installation and shall be used only as a source for temporary heat.
Before plugging the heater into the outlet, ensure by visual inspection that the unit is intact and has not suffered
any damage during transit.
Ensure heater is be placed on a flat stable surface.
NOTE: To prevent overloading circuit, avoid plugging the heater into a circuit that is serving other electrical needs.

Overheat Protection

If the heater grill is obstructed, or if the heater gets too hot for any reason, the automatic overheat protection device will
turn the heater off.
To reset the heater, simply turn power off and unplug heater for 10 minutes until it cools down, then you may plug heater
in and restart.

Safety Tip-Over Protection

Heater has a safety tip-over switch to turn power off should the heater tip over.
To resume heater function, simply place heater back in its upright position.
HOT SURFACES
Do not touch body of heater when in use. Heater becomes hot when in use. Use handle when moving this heater.
FIRE HAZARD
Do not use near combustible materials or flammable gases or sources of heat.
Do not use in areas where gasoline, paint or flammable materials are used or stored.
Keep combustible materials such as pillows, bedding, curtains, clothes, paper or furniture at least 0.9m (3') from the sides and rear of heater.
To prevent risk of fire, do not block air intakes or exhaust in any manner or allow foreign objects to enter any ventilation
or exhaust opening.

IMPORTANT INSTRUCTIONS

Basic safety precautions should always be
followed to reduce the risk of electric shock,
fire or injury to persons. Carefully follow all
application and safety instructions as per the
information provided with this product.

WARNING

MODEL #65019