Flurida FDFM1JA01 Quick Start Manual

Portable nugget ice dispenser
Hide thumbs Also See for FDFM1JA01:

Advertisement

Quick Links

https://www.fluridaappliances.com/product/countertop-nugget-ice-dispenser/
FDFM1JA01 Portable Nugget Ice Dispenser

Clearance Requirements

CAUTION
This unit is designed for countertop installation only.
 Do not block the air vent on left side.
 Allow for minimum 12 inches of clearance on the left side.
 Allow for minimum 2 inches of clearance on the back.
 Allow for minimum 1/2 inch of clearance on the top.

Electrical Requirements

It is required that you connect this unit only to a GFCI protected
receptacle. It is strongly recommended that you do not use an adapter
DANGER
or an extension cord to connect this unit because of potential safety
hazards.
 A dedicated 120V, 60Hz, 15A fused, grounded electrical supply is
required. It is recommended that a separate circuit serving only your
appliance be provided.
 Only connect to properly polarized outlets.
 Use outlets that cannot be turned off by a switch.
 Only plug the unit into a grounded 3 prong outlet.

FIRST TIME USE

1. Filling the water reservoir for the first time use

 Remove the reservoir door by pulling its two sides outwards.
 Add potable water to MAX WATER FILL.
Replace the magnetically attached door.
w w w . f l u r i d a a p p l i a n c e s . c o m
Quickstart Guide

INSTALLATION REQUIREMENTS

USE OF DISPENSER

For the first time use flush the unit following instructions below.
For the first time use dispense several cups of ice and then discard
them.
Do not overfill the reservoir otherwise it may overflow when ice
melts completely.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FDFM1JA01 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Flurida FDFM1JA01

  • Page 1 FDFM1JA01 Portable Nugget Ice Dispenser Quickstart Guide INSTALLATION REQUIREMENTS Clearance Requirements CAUTION This unit is designed for countertop installation only.  Do not block the air vent on left side.  Allow for minimum 12 inches of clearance on the left side.
  • Page 2 2. Flushing the unit for the first time use  Plug the unit into power.  Press and hold Clean button for 3 seconds to start the Cleaning mode for flushing process.  Unplug the unit when the flushing process is complete (it takes 30 minutes and the Cleaning LED goes off).
  • Page 3 Filling the water reservoir when the Water Level red LED flashes Do not add water until Water Level red LED flashes. NOTE Do not overfill the reservoir otherwise it may overflow when ice melts completely.  Push the fill port door to open. ...

Table of Contents