M-Bus Master Modules - Kamstrup M-Bus Master Manual

The modules are easily mounted in the
M-Bus Master bracket.
M-Bus Modem module
See the
To be mounted in the M-Bus Master and
installation
connected to a standard PSTN telephone
instructions
line.
on the modules
for further The M-Bus Modem is a self-dial modem.
When it calls up, it establishes a open
information.
communication line between the station's
PC and the M-Bus system. It is thereby
possible to carry out remote reading of
a complete M-Bus system.
After installation, the modem must be
activated with a forced call. Press both
buttons on the M-Bus Master for at least
10 seconds – until "Call" is displayed.
Please contact Kamstrup A/S for further
information.
M-Bus Master with cascade module
Usefull numbers:
8.

M-Bus Master modules

Terminal 24-25, 2 sets of terminals
towards the next 38 Slaves
Terminal 53 and 54,
towards the M-Bus Master
M-Bus Modem module with DTMF dialing 66-98-002-319
M-Bus Cascade module
M-Bus Cascade module
Allows an increase of the number of
Slaves in a network and makes it possible
to extend the cable length up to 12.000
meters. The module is mounted in an
M-Bus Master. The M-Bus Master and
module must be supplied with 230 VAC.
Terminals 24 and 25 of the cascade
unit provide connection for the next
38 MULTICAL ® energy meters with M-Bus
Slaves.
Terminals 53 and 54 are connected to the
existing network towards the first M-Bus
Master. See paragraph 9.
Terminal 27 and 28, 230 VAC
66-98-001-100
11