Summary of Contents for Rejuvenation ELKTON
- Page 1 Assembly instructions Instructions d’assemblage Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com ELKTON DOUBLE SINK VANITY...
- Page 2 Assembly instructions Instructions d’assemblage Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com BEFORE YOU BEGIN Marble top is both heavy, and until installed, fragile. Please have a helper and use caution when moving marble top. Make sure to observe all local plumbing codes. Prior to installation, unpack and inspect both the console and marble top and porcelain lavatory for damage. Locate the installation parts package and put in a safe place—you will need this for installation. Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid accidentally discarding small parts or hardware Installation assumes that walls and floor are plumb and level. Please make appropriate adjustments for other conditions. Remove any molding that may prevent the console from being set flush to the finished wall. TOOLS AND MATERIALS Tape measure Pencil Level Drill with appropriate drill and driver bits Eye protection Clear 100% silicone adhesive caulk ...
- Page 3 Assembly instructions Instructions d’assemblage Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com ∅8 x 2 3/4" – 4x...
- Page 4 Assembly instructions Instructions d’assemblage Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com TEST FIT THE VANITY BASE • Remove the drawer: 1. Pull open the drawer. 2. Remove the 4 screws on the underside of the drawer that attach drawer slide to the drawer .
- Page 5 Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com TEST FIT THE VANITY BASE (cont’d) Position the vanity base in the desired location against the finished wall. Verify that the vanity base is level: front to back and side to side. Adjust the levelers at the...
- Page 6 Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com INSTALL THE VANITY BASE AND MARBLE TOP • Locate two wall studs to secure the vanity base. Mark these locations on the back rail of the vanity base. Drill pilot holes through the back rail and into the studs. If necessary provide shims between vanity and back rail so the back rail is not distorted.
- Page 7 Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com INSTALL THE SINK AND FAUCET • Temporarily position the sinks over the cutout and make sure that it is aligned properly. • Apply several pieces of blue painters tape on both the countertop and sink. Make marks on tape as an alignment guide for final installation.
- Page 8 Instructions d’assemblage Instrucciones de Ensamblaje 2018.03.20 www.rejuvenation.com REINSTALL THE DRAWER 1. Extend the drawer slides and note the alignment hook on the back of each slide. 2. Note the notched holes at the back of the drawer. 3. Set the drawer onto the slides so that the drawer slide hook fit into the notches.
Need help?
Do you have a question about the ELKTON and is the answer not in the manual?
Questions and answers