KATA TST Tripod Holder Manual

TST TRIPOD HOLDER
Kata’s TST Tripod Holder is a modular and
versatile component. It can be connected to
most KATA backpacks:
BP-502
Panda-402
R-102/3
HB-205/7
The TST Tripod Holder includes the pouch
and an upper fastening strap.
Name:
R-102/3 BP-502
KT R-102/3 KT BP-502
Order code:
Side attachment configuration
Attachment stages:
Adjust hanging height according to the length of
1
your tripod:
Open the top Slik-clip buckles on the back of the
pouch (these can be opened from either side)
and slide them through the loops on the side of
the backpack.
Note:
It is possible to adjust the height of the pouch by
utilizing the vertical connecting loops which are
on the backpack. This allows you to achieve
optimal weight distribution.
Secure the Slik-clip buckle through one of the
2
loops on the opposite strap of the pouch.
Insert two of the tripod legs in the TST tripod
3
holder (the third is meant to be left outside nestling
in the designated groove).
Secure the top of the tripod with the fastening
4
strap .
Slide the strap through one of the upper vertical
connecting loops and fasten firmly.
1
Slik-clip
connecting
buckle
Additional front attachment position for R-102/3 HB-205/7
This configuration offers symmetrical
weight distribution without compromising
the front quick opening for camera access.
Attachment stages:
Connect the 2 Slik-clip buckles to the top
1
parallel tabs on the R-102/3 HB-205/7 front
panel, and slide the fastening strap through.
According to the size of the tripod in use
2
connect the 2 Slik-clip buckles of the pouch
to the appropriate lower parallel tabs.
It is possible to adjust the height of the TST
tripod holder for optimal weight distribution
by using any of the 3 sets of parallel tabs
set at various heights.
HB-205/7
PANDA
KT HB-205/7
VE-402
2
1
2
Fastening strap
Vertical connecting loops feature
Pouch
on Kata backpacks
3
1
2
4
Secure the top part of the tripod with the
3
fastening strap .
Slide the strap through the two upper Slik-
clip buckles and fasten firmly.