Wolf FWS-2-60L Manual page 15

Installation
Wall mounting
Installation on a stratification
cylinder
Threaded sleeves
3064342_201505
Freshwater module installation instructions
Positioning and installation may only be carried out by an authorised contractor.
The system must be installed in a location that is protected from frost.
Use the mounting hardware supplied with the system (2 x M10 x 100 threaded
studs + 2 x M10 nuts + 2 x M10 washers) to install it on a stratification cylinder.
After installing the buffer cylinder insulation, turn the threaded studs about 5 mm
into the threaded sleeves located on the cylinder.
Use the corrugated pipe cylinder connection set, a secure and time-saving
connection, for installing the system on stratification cylinders.
15