Table of Contents
Advertisement
Quick Links
PPS User Manual
Rev 1-2015 ENG MASTER
Actsafe_Power_Supply_Manual_vAW_v3.indd 1
PPS
PORTABLE
POWER SUPPLY
Disclaimer
About ActSafe
Safety messages and warnings
Product safety
System description
Pre-use inspection
and connection
General safety
operating guidelines
Set-up
Trouble-shooting guide
Performance
Warranty terms
Declaration of conformity
Technical data
A
B
C
D
E
F
G
H
I
J
K
L
M
07/04/2015 14:14
Advertisement
Table of Contents
Summary of Contents for ActSafe PPS
- Page 1 PPS User Manual Rev 1-2015 ENG MASTER PORTABLE POWER SUPPLY Disclaimer About ActSafe Safety messages and warnings Product safety System description Pre-use inspection and connection General safety operating guidelines Set-up Trouble-shooting guide Performance Warranty terms Declaration of conformity Technical data Actsafe_Power_Supply_Manual_vAW_v3.indd 1...
- Page 2 DISCLAIMER This manual is intended for use with the ActSafe ActSafe Systems AB disclaims any liability Portable Power Supply which is only to be used in tort for damages or direct or consequential in combination with the ActSafe ACCII Power...
- Page 3 ABOUT ACTSAFE We are completely committed to our customers ActSafe is a pioneer in developing powered rope ascenders and have been delivering and do our utmost to deliver top quality high performance equipment since 1997. products and service. ActSafe has a worldwide distribution...
- Page 4 This manual details information on features and safety. However, this manual cannot replace the DANGER need for training and experience. The ActSafe Not following instructions or training Portable Power Supply must only be used methods may result in SERIOUS INJURY by operators who have undergone the or DEATH.
-
Page 5: Product Safety
PRODUCT SAFETY The ActSafe Portable Power Supply is only Do not: to be used in conjunction with the ACCII » Use the Power Supply to charge Power Ascender. any batteries The Power Supply must not be used » Open the Power Supply under... -
Page 6: System Description
SYSTEM DESCRIPTION Securing/carrying strap Air vent Machine Rating Label This Power Supply is Power output supplied with a machine Power/overheat indicator LED rating label attached to the housing. This label 220V Power cable must not be removed. ACC Power Supply cable Actsafe_Power_Supply_Manual_vAW_v3.indd 6 07/04/2015 14:14... - Page 7 Pre-use inspection: Connecting Power Supply: Perform before every use a pre- 1. Make sure the Power Supply use check of the ActSafe Portable is installed in a secure place Power Supply: 2. Connect the Power Supply 1. Check main supply cable and cable between the Power plug for damage.
- Page 8 OPERATING GUIDELINES » Use only approved Inspection intervals and inspected equipment The ActSafe Portable Power Supply must be checked before and after every use and » Make sure you have a steady must be subject to at least one inspection per 220 V 50/60 Hz grounded power year.
- Page 9 SET-UP The ActSafe Portable Power Supply should only be used in applications where the Ascender is rigged to an anchor and therefore remains in a fixed position where the Power Supply can easily be connected to a 220V socket. The Power Supply must not be used connected to long power cables whilst moving the Ascender up and down the rope.
-
Page 10: Troubleshooting Guide
Recharge the battery c TROUBLE-SHOOTING GUIDE If you need further assistance or are in any doubt, please contact ActSafe Systems or an ActSafe approved distributor. Problem Probable cause Remedy Power Supply not plugged in socket Check that the Power Supply is plugged-in... - Page 11 PERFORMANCE ActSafe Portable Power Supply ACCII Laboratory tests have shown that The Power Supply is a nearly unlimited The nearly unlimited supply of power the overheat protection will be source of power that enables you to carry will have, under extreme conditions,...
-
Page 12: Warranty Terms
ActSafe approved » ActSafe will repair or, if necessary » The product is modified, maintained service center performing such service. in ActSafe’s opinion, replace any... - Page 13 ActSafe disclaims all other warranties, the sole and exclusive remedies with express or implied or statutory, respect to any breach of the ActSafe’s including, but not limited to the implied limited warranty set forth herein. warranties of merchantability or fitness for a particular purpose.
-
Page 14: Declaration Of Conformity
DECLARATION OF CONFORMITY EC DECLARATION OF CONFORMITY Machinery Directive 2006/42/EC Manufacturer: ActSafe Systems AB, Sagbäcksvägen 13, 437 31 Lindome, Sweden It is hereby is certified that the is made according to: following product DIRECTIVE 2006/42/EC Description, ID/mark, type: ActSafe Power Supply for ACC II... - Page 15 Weight 42x24x16 cm Dimensions IP 55 Protection classification Ascender cable length 2.2 m Mains cable length PPS WITH CARRY CASE 12.6 kg Total weight: Case & PPS 44x57x22 cm Case dimensions IP 67 Case protection classification Actsafe_Power_Supply_Manual_vAW_v3.indd 15 07/04/2015 14:14...
- Page 16 DISTRIBUTOR ActSafe Systems AB T: +46 31 65 56 60 Sagbäcksvägen 13 E: info@actsafe.se SE-43731 Lindome, Sweden © 2015 ActSafe Systems AB Actsafe_Power_Supply_Manual_vAW_v3.indd 16 07/04/2015 14:14...
Need help?
Do you have a question about the PPS and is the answer not in the manual?
Questions and answers