Coopers G345 Instructions For Use

Slate Garden Clock
Please read and retain these instructions for future reference

Clocks, Thermometers and Humidity Meters:

Carefully unpack the product from its box and packaging.
Depending on the product type, you may find that it is fixed to the inner box by means of two or more small
screws located on the back of the box.
To take the clock out of the box, unscrew all of the screws on the back of the box whilst ensuring that the
clock is supported to avoid it falling out.
Battery Installation – Clock:
Open the battery compartment at the rear and fit a 1.5V (AA or equivalent) battery into the battery
compartment taking care to observe the correct polarity. (+/-). Battery not supplied.
Adjust the time by turning the wheel on the movement in the required direction until the current time is
displayed.
The rear cover should now be replaced.

Thermometer:

The Thermometer is designed as a guide to measuring the temperature to within +/- 3ºC.
Temperature readings should only be taken when the thermometer is in the shade or has been in shaded
conditions for several hours.
Occasionally after transit, the thermometer may need to be re-calibrated and this is simply carried out by
unscrewing the protective cap covering the thermometer mechanism and by carefully turning it in an anti-
clockwise direction to read a higher temperature and a clockwise direction to read a lower temperature.
Upon turning the mechanism, the pointer on the front will be seen to move and can be calibrated against a
known source, i.e. another thermometer. Please ensure to be extra careful when carrying out this procedure
to avoid damaging the mechanism. Replace the protective cap once completed.
G345
Dimensions: 33.5 X 33.5 X 5 CMS approx.
Weight: 1.65KG approx.

Power Supply:

1 x 1.5 (AA or equivalent) battery (not supplied)
Instructions for Use
v001: 21/10/19