Advertisement
Initial Configuration
1
Step
Configure the vEdge router:
From vManage > Configuration >
a
Devices > WAN Edge List, upload the
WAN Edge authorized serial number file.
From vManage > Configuration >
b
Certificates > WAN Edge List:
a. Check that the router's chassis and
serial number are in the WAN Edge list.
b. Authorize the router by clicking
Valid in the Validate column.
c. Click Send to Controllers to send the
WAN Edge list to the controller devices.
From vManage > Configuration >
c
Templates:
a. Create a device template for
the vEdge router.
b. Attach the router to the device
template.
4
CONSOLE
RESET
GPS
071118
Copyright © 2018, Cisco Systems, Inc.
Initial Configuration
2
3
Step
Step
Boot the vEdge router:
Connect LAN and WAN interfaces
Connect to the LAN by plugging the
a
Plug one end of the power adapter
a
appropriate cable into any port, except
cord into the front of the router.
port 4, on the front of the router.
Secure the cord in place by loosening
b
Connect to a WAN by plugging the
the cable clamp screw, tucking the cord
b
appropriate cable into port 4 on the
under the clamp, and then tightening
front of the router.
the screw.
Insert the appropriate connector for
c
your geographical location into the other
end of the cord. Then plug the cord into
an AC power outlet.
AUS
US
UK
EU
4
Step
Verify vEdge router status:
PWR
SYS
From vManage > Dashboard or from
DC 12V IN
PWR
0
1
2
3
4
CONSOLE
RESET
GPS
vManage > Monitor > Network >
Device Dashboard, verify that the vEdge
router is operational.
Caution: If you are connecting AC power to the
router, it is recommended that the building have
an external surge protective device installed.
Initial Configuration
:
0
1
2
3
4
CONSOLE
RESET
GPS
LAN
WAN
Advertisement
