Page 1
AEP1100/AEP1200 is a PCI Ethernet Board, the PCI bus design allows AEC1100/AEP1200 to transfer data between the network and station at PCI system clock speed with high throughput rate. AEP1100 is equipped with ST multi-mode connectors (Tx, Rx), while AEP1200 is equipped with SC multi-mode connectors (Tx, Rx).
Page 2
When installing multiple AEP1100/AEP1200 boards at the server station, • you should configure the PCI slots IRQ settings correctly. Up to four AEP1100/AEP1200 can be installed in a PCI fiber server running NetWare system. Each AEP1100/AEP1200's IRQ should not conflict with other installed boards/devices 4.
Page 3
: x (PCI slot IRQ no.) RPL-ROM-PIO : x000 (PCI slot IO address) ADR is the Ethernet Node Address of AEP1100/AEP1200. IRQ and PIO are PCI slot configuration and configured by your system PCI BIOS. 7. Diagnostic & Driver Setup...