Table of Contents
Advertisement
A Word on the Exclusive 3N-100AAS
Battery Pack
The nickel-cadmium battery pack (3N-100AAS) is used for
power source of the built-in clock and memory circuit.
Charging the Battery Pack
1. Turn on the power of the VCR.
2. The battery pack in the VCR is charged.
Battery Installation
Removal:
1. Remove the battery cover.
2. Disconnect the connector in the VCR.
RED wire
Connector
Installation:
1. Install the battery pack placing the red wire upside, and
connect the connector on the battery pack to this VCR.
Make sure the polarities (+) and (–) are correct.
2. Close the battery cover.
Note:
If the Battery Pack is removed, the memory data will be
erased. In such a case, perform the setting from the first step.
Battery pack
Specification of Battery
i
Temperature
For charging
:
0°C to 80°C
For operating
:
–20°C to 80°C
For storing
:
–30°C to 80°C
i
Charging time
:
more than 48 hours
Notes:
i
Use only for this VCR.
i
Do not dispose of the batteries into fire.
i
Do not short circuit the terminals.
i
Do not modify or disassemble.
i
Avoid dropping, unnecessary shocks.
8
Advertisement
Table of Contents
