Summary of Contents for JCM EBA-10-SD2
- Page 1 Europe Bill Acceptor EBA - 10 - SD2 CHAPTER 6 Trouble Shooting DWG No. 990 - 1 1 - 0 6 - 01 Date 97- 02...
- Page 2 Introduction Many troubles of the validator are caused by minor reasons. Before replacing any part, be sure to check whether connectors are connected properly and there is no line breakage in a cable harness. If the validator rejects a bill frequently, the magnetic head and magnetic head roller may have a layer of iron particles on them.
- Page 3 1- Outline of troubleshooting EBA can find a trouble cause by performing the "bill identification operation test". Theperformance test or sensor adjustment is performed according to the identified troublecause and the necessary repairs and replacement of parts are performed. VM-450 Investigation of trouble cause Investigation of trouble cause 2 Connecting the EBA and VM-450...
- Page 4 3 Bill Identification Operation Test Procedure 3-1 To perform the bill identification operation test, first set the acceptor to the test mode standby status. Set the DIP switches of EBA-1 0/41 0 and VM-450 as shown in the figure below. Make sure to turn off VM-450 before changing the DIP switch EBA-10/410 DIP switch setting 3-2 When you turn on the power of VM-450, the BSY LED lights and "_000__ 00"...
- Page 5 Do not use bills like the ones below to confirm the bill receiving operation. If you insert such a bill it will not be identified properly. (a) Bills that are dirty, worn, wet, torn, and badly wrinkled. (b) Bills with folded and overlapped corners or edges. (c) Bills that have considerably different cutting dimensions and printing displacement.
- Page 6 5 Trouble Classification The trouble causes are mainly divided into the following 6 types. Check the operating conditions.
- Page 7 (1) Test mode can not be started. (2) Indication LED does not turn on. (3) Normal signal can not be send from acceptor to controller.
- Page 8 (4) Bill is rejected and rate of receiving bills is poor. Check whether the ROM being used complies with the country corresponding to the currency. *1: See Chapter 7, "Adjusment Manual" for details about the sensor adjustment. *2: Determine the defective position from 6 " Error Message" in the Adjusment Manual and replace the parts as required.
- Page 9 (6) Bill is not accepted. The LED next to the DIP switch flashes repeatedly. ( Stop state due to malfunction ) Performance test Check 3-(1) (Acceptor forward rotation test) Check 3-(2) (Acceptor forward rotation test) *1: See Chapter 7, " Adjustment Manual" for details about the sensor adjustment.
- Page 10 6 Error Code Slow flash (1) Error Code ( Malfunction ) List No. of times LED flashes Description of error (1) Detected stacker full. (2) Operation of the insertion slot unit is lagging. (1) Insertion slot unit operation error. (2) No signal is sent from the stacker home position sensor. (3) No signal is sent from the stacker encoder.
-
Page 11: Performance Test
Performance Test...
Need help?
Do you have a question about the EBA-10-SD2 and is the answer not in the manual?
Questions and answers