1. Manuals
  2. Brands
  3. Augmented Vision Labs Manuals
  4. Medical Equipment
  5. S5 Inserter
  6. User manual

Augmented Vision Labs S5 Inserter User Manual

Hide thumbs Also See for S5 Inserter:
1
2
3
4
5
6

Advertisement

Table of Contents

S5 Inserter
TM
User Manual
Table of Contents
1. Device description .................................................................... Page 2
2. Safety precautions (*read before use) .................................. Page 2
3. Instructions for use .................................................................. Page 3
4. Device maintenance ................................................................ Page 5
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S5 Inserter and is the answer not in the manual?

Questions and answers

Related Manuals for Augmented Vision Labs S5 Inserter

Summary of Contents for Augmented Vision Labs S5 Inserter

  • Page 1 S5 Inserter User Manual Table of Contents 1. Device description ………………………………………………………….. Page 2 2. Safety precautions (*read before use) .…………………….…….. Page 2 3. Instructions for use …………………….………………………………….. Page 3 4. Device maintenance ….………………………………….……………….. Page 5...
  • Page 2 More information is available in the handout provided with the lens holder. c. The lens holder provided with the S5 Inserter™ is only intended for use in lens insertion. Do not use the provided lens holder during lens removal. d. CHOKING HAZARD: Keep the lens holder and its case away from small...
  • Page 3 Instructions for use Before lens insertion 1. Place the base on a smooth, flat surface. Ensure that both the bottom of the suction base and the surface are clean and dry. 2. Press down on the base while pulling the metal telescoping arm upward until it locks into place in the vertical position.
  • Page 4 10. Fill the lens bowl with a preservative-free saline solution that is approved by your doctor. Add saline until the level goes higher than the edge of the lens (see the photo on page 1 for reference). Lens insertion 1. Use both hands to firmly hold your upper and lower eye lids open. 2.
  • Page 5 3. Extend the telescoping arm to its full length and use a dry towel to remove any moisture from the telescoping arm. Do the same for the light unit (especially the metal USB plug) and suction base. Device Maintenance 1. Make sure to remove any liquid that may have spilled onto the light unit, telescoping arm or suction base after each use.
  • Page 6 4. Clean the rubber lens holder with alcohol before every use and allow it to dry completely before placing a lens on it. 5. Store the device in a dry, cool place when not in use.

Table of Contents