Download Print this page

True TurboSpeed TCG220-T Setup

Wireless

Set up Wireless for TurboSpeed TCG220-T

Set up 802.11Band and Channel

1. Type

192.168.1.1

then press Enter, type Username = admin,

Password = password and press Login

Table of Contents

Do you have a question about the TurboSpeed TCG220-T and is the answer not in the manual?

Page 1 Set up Wireless for TurboSpeed TCG220-T Set up 802.11Band and Channel 1. Type 192.168.1.1 then press Enter, type Username = admin, Password = password and press Login...
Page 2 2. On top, click Wireless > Radio, set up as follows:  Wireless Interface : choose to set Wireless channel, select Mac Address and at 802.11 band, check to see if it is 2.4GHz or 5GHz  Wireless : Enabled ...
Page 3 Set up SSID and Security 1. On top, click Wireless > Primary Network  Primary Network : Enabled  Network Name (SSID) : enter network name  Select Enabled at WPA-PSK and WPA2-PSK  WPA/WPA2 Encryption : AES  WPA Pre Shared Key : set password to use Wireless (click Show Key to see the password typed) ...
Page 4 2. It is not recommended to set up WEP since it’s old Security system, click Apply...
Page 5 Set up MAC Filter 1. On top click Wireless > Access Control > MAC Restrict Mode  Disabled : do not use this function  Allow : allow the access only specific MAC Address  Deny : not allow the access only specific MAC Address ...
Page 6 Set up WDS 1. On top, click Wireless > Bridging > Wireless Bridging then select Enabled to set up WDS by entering Wireless MAC Address of main Wireless Router (mostly Router should be the same brand and then click Apply model)