Summary of Contents for Power Your Fun UFO1
- Page 1 Ages 14+ INTERACTIVE LED STUNT DRONE U SER MAN UAL OBSTACLE Altitude 360° AUTO VARIABLE vibrant AVOIDANCE Hold Flip LAUNCH SPEEDS leds Visit us online at www.powerurfun.com for product information and replacement parts.
-
Page 2: Product Dimensions
UFO1 User Manual Product Dimensions: 2” 6.7” 6.7” WA RN I N G • Please follow and retain this instruction manual for proper installation and use. • Some parts must be assembled by an adult. • Choking Hazard: Product contains small parts. - Page 3 3. Remove the ba eries from the transmi er when storing for extended periods of time. 4. If the UFO1 collides and falls to the ground, allow the drone to reorient itself on a horizontal surface for 2-3 seconds before flying again.
- Page 4 Remote Transmi er Ba ery Installation 1. Remove the ba ery cover with the included screwdriver. 2. Install 4 AAA ba eries with appropriate polarity direction. 3. Reinstall the ba ery cover with the included screwdriver. ATTENTION A. The positive and negative electrodes of the ba eries should match the corresponding polarity of the ba ery compartment.
- Page 5 Please do not short-circuit the ba eries. Pairing the Drone Before Operation 1. A er the ba ery is properly connected, place the UFO1 on a flat horizontal surface and long-press the drone’s power switch. The drone’s LED lights will flicker on and off.
- Page 6 Basic Flight Control Push the thro le stick Ascending upward, the drone will ascend. Push the thro le stick backward, the Descending drone will descend. Rotate Le Push the thro le stick to the le , the drone will rotate le . Push the thro le stick to Rotate Right the right, the drone will...
- Page 7 Flight Trim Controls A er launching your drone, you may experience unintentional dri ing or rotating. To fine-tune your drone’s flight stability, please follow the trim adjustment procedures described below. Note: When the drone is 1 foot above the ground, it will become unstable due to the influence of its own blade eddy current, which is called the “ground effect response.”...
-
Page 8: Headless Mode
Infrared Induction Mode When you are in Induction Mode, you may enter into Remote Control Mode by powering the remote transmi er ON and then pressing the thro le stick up and then down. You will then have full control of the drone. To enter back into Induction Mode, turn the remote transmi er OFF, then press the bu on on the droplet remote.
Need help?
Do you have a question about the UFO1 and is the answer not in the manual?
Questions and answers