Inserting Batteries - Toshiba MD20F51 Owner's Manual

Introduction
Identification of controls (Continued)

Inserting batteries

1
Open the battery compart-
ment cover in the direction of
the arrow.
Operation
• Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5
meters.
Caution:
• Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Attention should be drawn to the environmental aspects of battery disposal.
• Do not mix different battery types or combine used batteries with new ones.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace both
batteries with new ones.
• If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to
prevent battery acid from leaking into the battery compartment.
12
5S10101A [E] (P08-12)
2
Install two "R03/AAA"
batteries (supplied), paying
attention to the polarity
diagram in the battery
compartment.
Illustration of MD24F51
12
3
Replace the compartment
cover.
Approx. 5 meters
2/5/05, 9:41 AM