Advertisement
Quick Links
INSTALLATION
Caution: All installation types need to allow room for faucet installation.
Ensure adequate clearance behind the basin for your faucet and backsplash,
as well as the full range of motion for faucet handles and spouts. All basins,
especially under mount and apron front installations, should be installed by
professional installers.
The Sinkology Dual-Flex rim is designed with a Flat Standard
under-mount rim, also has a slight curve at the end to allow for
decorative and flexible drop-in installation.
Advertisement
Summary of Contents for Sinkology Dual-Flex rim
- Page 1 The Sinkology Dual-Flex rim is designed with a Flat Standard under-mount rim, also has a slight curve at the end to allow for decorative and flexible drop-in installation.
- Page 2 Step 6. Clean excess silicone. Silicone Apply polyurethane to seal the gap between the sink and countertop. Mount faucet. (Weight) Step 7. Treat copper sinks with Sinkology Copper Armor Spray Foam for maximum protection (apply based on directions on bottle).
- Page 3 Solid Surface Countertop to countertop. Brass Insert Bracket (only bracket included) Washer Wingnut Bowl Screw Step 5. Clean excess silicone and mount faucet. Step 6. Treat copper sinks with Sinkology Copper Armor for maximum protection (apply based on directions on bottle).
- Page 4 Counter Top supplied Washer. Steel Washer Brass Locknut Step 4. Clean excess silicone and mount faucet. Step 5. Treat copper sinks with Sinkology Copper Armor for maximum protection (apply based on directions on bottle).
- Page 5 If you are unfamiliar with installing bathroom fixtures and plumbing, we recommend consulting a professional. Keep plumbing connections around the tub easily accessible for future maintenance that may be necessary. Sinkology does not accept liability for any damage to the floor, walls, plumbing, or for personal injury during installation.
- Page 6 BATHTUB – FREESTANDING INSTALLATION (CONT.) Rough-In Waste Drain and Waterlines: Note: Sinkology copper bathtubs are handmade so variations in dimensions can occur. We recommend performing Rough-In procedures with the bathtub on site to ensure the correct installation. Loosely assemble selected freestanding bathtub waste drain or overflow kit onto bathtub (leaving off the tailpipes at this time).
- Page 7 These sinks will not have install clamps and need to be installed using 100% silicone. CAUTION: Tighten claws only until sink rim is flush with counter top. Do not over tighten. Step 5. Treat copper sinks with Sinkology Copper Armor for maximum protection (apply based on directions on bottle).
- Page 8 Use a level to make sure that the basin is sitting flush in all directions, while pressing down to seal. Step 5. Clean excess silicone and mount faucet. Step 6. Treat copper sinks with Sinkology Copper Armor for maximum protection (apply based on directions on bottle).
- Page 9 Apply silicone around the top edge of the basin. Place the countertop around the basin. Ensure it is centered and remove any excess silicone. Step 6. Install the drain mount. Step 7. Treat copper sinks with Sinkology Copper Armor for maximum protection (apply based on directions on bottle).
Need help?
Do you have a question about the Dual-Flex rim and is the answer not in the manual?
Questions and answers