Table of Contents
Advertisement
PIONEER
LINE VOLTAGE AND REAR PANELS
CT-F900 are designed to accept different line
voltages, according to the country in which they
are to be used, although the operation of the
various models is the same in every respect. Fig. 13
shows the model designed to operate at any of two
pre-selected voltages>(220V, 240V).
Fig. 14 shows the*model designed to operate at any
of three selected voltages (120V, 220V, 240V).
Line voltage and fuse can be changed and set as
follows:
220V and 240V MODEL
1. Disconnect the A.C. mains cord.
2. Use a Phillips screwdriver to take out the Fuse
cap and fuse (Fig. 15).
3. Pull out the VOLTAGE SELECTOR plug from
the socket.
4. Rotate the plug until the cutaway aligns with
the appropriate line voltage marker on the back
of the unit, and then replace it in the socket.
5. Replace the fuse and FUSE CAP.
120V, 220V and 240V MODEL
1. Disconnect the A.C. mains cord.
2. Use a Phillips screwdriver to take out the FUSE
CAP and fuse (Fig. 15).
3. Pull out the VOLTAGE SELECTOR plug from
the socket.
4. Put the selector plug back so that the appro¬
priate line voltage marking can be seen through
the cut in the edge of the plug.
5. Change the fuse in accordance with the table.
6. Replace the fuse and FUSE CAP.
220V, 240V model Rear Panel
FOR YOUR SAFETY
1. Insert this plug only into effectively earthed three-
pin plug-socket outlet,
2. If any doubt exists regarding the earthing
;
consult a
qualified electrician
,
3. Extension cords
,
if used, must be three-core correctly
wired.
FOR USE IN UNITED KINGDOM OR AUSTRALIA
CAUTION 240V:
MAINS
SUPPLY
VOLTAGE
IS
FACTORY ADJUSTED AT 240
VOLTS.
WARNING:
THIS APPARATUS MUST BE EARTH¬
ED.
IMPORTANT
The wires in this mains lead are coloured in accordance
with the following code:
Green-and-yellow:
Earth
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured mark¬
ings identifying the terminals in your plug proceed as
follows.
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
by the letter E or by the safety earth symbol
■
4
*
or
coloured green or green-and-yellow,
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
*
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
The power cord should be connected last
,
make sure
that the power switch is off First insert the female
appliance connector of the mains cord into the AC
INLET\ then plug the cord to the wall socket
.
Be sure
that the appliance connector is fully inserted into the
AC INLET. Unplug the set from the wall socket when it
is not be used for an extended period of time
.
PIONEER ELECTRONIC CORPORATION
-4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153, Japan
U.S. PIONEER ELECTRONICS CORPORATION
B5 Oxford Drive, Moonachie, New Jersey 07074, U.S,A,
PIONEER ELECTRONIC (EUROPE! N.V. Luithagen-Haven 3, 2030 Antwerp. Belgium
PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 17B-1B4 Boundary Road, Braeside, Victoria 3135, Australia
Printed in Japan
<RRB~095~A>
Advertisement
Table of Contents
