Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for VascuEase IC-1200-WH
- Page 1 REF IC-1200-WH Quality Medical Products Since 1983 Instructions for Use...
-
Page 2: Table Of Contents
Table of Contents Introduction ........................3 Intended Use ........................3 Device Description and Operating Principle ............... 3 Warnings and Precautions ................... 5 Operating Instructions ....................6 Accessories ........................9 Product Specifications ....................9 Environmental Specifications ..................10 Symbol Glossary ......................14 Information for Distributors and Healthcare Providers ........... -
Page 3: Introduction
DVT. The pump will inflate each leg garment to a preset pressure and deflate after a period of time. The cycle continues until the unit is turned off. Internal rechargeable batteries allow the VascuEase to be completely portable, allowing for continued treatment without interruptions. Instructions... - Page 4 Guidelines for Treatment A physician is required to prescribe these settings, but general guidelines are listed below: • Deep vein thrombosis (DVT) prophylaxis should be applied continuously, around the clock, unless otherwise ordered by the attending physician. A less aggressive treatment schedule is more commonly prescribed by the physician post discharge in the home setting.
-
Page 5: Warnings And Precautions
Warnings and Precautions US federal law restricts this device to sale by or on the order of a physician. Electrical Medical Equipment • To avoid the risk of electric shock, burns, fire, injury, or improper treatment, read the entire instruction manual before operating this device •... - Page 6 Stop Use And Ask A Doctor If • Changes in skin appearance occur such as color changes, blisters, welts, or increased swelling • You feel burning, itching, increased pain, numbness, or tingling In the event the pump stops working (e.g., power failure), release pressure by disconnecting the garment.
-
Page 7: Operating Instructions
Operating Instructions The patient is the intended user and can safely use all functions. Preparing the Device for Use • Remove garments and cardboard underneath from box • Lift re-shipper box out of outer box and open • Remove pumps and charger – save packaging for transport and storage •... - Page 8 will then emit a series of short beeps to indicate the hours of use. For example, if the pump emits 3 short beeps followed by 5 short beeps, that indicates 35 hours of use. When complete, you will hear another long beep. Cleaning The pumps and garments can be wiped down using a damp (not wet) soft cloth while unplugged –...
-
Page 9: Accessories
2. Plug in to check for solid yellow LED 3. If LED does not illuminate, check circuit breaker to make sure outlet has power 4. If LED does not illuminate or battery does not charge after 4 hours, contact Bio Compression Systems Accessories Description GID-1000-PR VascuEase DVT Garments... -
Page 10: Product Specifications
Product Specifications Models: IC-1200-WH Electrical Input Rating: 120-240 VAC, 50-60 Hz, 0.7 A (max) Electrical Classification: Class II Type Applied Part: Type BF Ingress Protection: IP22 Battery: 3.7 V Li-ion battery Charge Time: 4 hours Mains Isolation: Battery powered Mode of Operation: Continuous Essential Performance: The pump’s cyclical inflation and deflation of the garment(s) -
Page 11: Environmental Specifications
Environmental Specifications Consumables and Natural Resources Used During Care and Use • Electrical energy for operation • 1 drop of mild antibacterial soap and 2-3 cotton balls moistened with 70% isopropyl alcohol - only as needed • 70 mL laundry detergent and 250 mL bleach per 7.6 liters water for garment cleaning - only as needed Emissions During Normal Use •... - Page 12 • Dispose of in an environmentally responsible manner in accordance with regional requirements • Contact Bio Compression Systems if you have questions or concerns regarding disassembly and disposal Manufacturer’s EMC Declaration Electromagnetic Emissions The device is intended for use in the electromagnetic environment specified below. The customer or user of the device should assure that it is used in such an environment.
-
Page 13: Symbol Glossary
Symbol Glossary Authorized Representative in Manufacturer the European Community Atmospheric pressure limitation Medical Device Batch code (lot number) Keep dry Catalog number Power on/off (stand-by) Refer to instruction manual/ Caution booklet Class II equipment (protection Restricted to sale by or on the against electric shock) order of a physician Complies with the Waste... -
Page 14: Information For Distributors And Healthcare Providers
Information for Distributors and Healthcare Providers Resetting the Pump The pump remembers user settings and therefore it is important to reset the pump to its original factory settings when placing the device on a new patient. To reset the usage meter and return the pump to factory settings: •... - Page 16 L-226 J EN 2019-11...