Advertisement
INSTALLATION INSTRUCTIONS
4.
Route wires through center of mounting plate assembly. See Figure 5.
5.
Take wire harness assembly and make power connections using approved electrical connector.
See wire diagrams.
FIG 5
6.
Pack excess wire in center of mounting plate assembly and mount cover using #10 sealing weather resistant
screws supplied. See Figure 7.
7.
Complete installation by swinging fixture into place and securing with mounting screws using #2 Phillips driver.
See Figure 8.
FIG 7
US LED
| 6807 PORTWEST DR | HOUSTON, TX 77024 | T 866 972 9191 | F 713 972 9393 | info@usled.com | www.usled.com
INSTALLATION GUIDE
CNPx-50
FIG 6
FIG 8
Page 3
#44-000017
Updated 04.20.18
Advertisement
