Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Binzel Neutrix
- Page 1 NEUTRIX INSTRUCTION MANUAL Page 1...
-
Page 2: Table Of Contents
Technical data & contents of standard package Before use :- Selection of grinding position Selection of electrode diameter Selection of grinding angle Using the Neutrix Operating the Neutrix How to grind the electrode Maintenance: - Replacing the filter. Replacing the diamond wheel... -
Page 3: Manufacturers Recommended Use
Manufacturers recommended use Neutrix has been designed for the sole purpose of grinding tungsten electrodes. Any use, which is not described in this manual, is strictly prohibited. It is very important that the user reads and understands the contents of this instruction manual. -
Page 4: Drawings & Parts Description
Drawing & parts description Electrode holder guide Filter housing Eccentric plate to select Angle degree grinding position scale (1 step= 5 °) Grinding head Filter cassette Depth setting gauge. Machine Allen screw to tighten number the grinding head 25.2 Filter cover On/Off switch 25.3 Allen screw to... - Page 5 Electrode holder guide Knurled wheel Grinding stop Inspection Diamond wheel cover Spindle for diamond wheel Allen screw Electrode clamp 5 Electrode holder Stop Part Nos for electrode clamps 16.1 1.0 mm 16.2 1.6 mm 16.3 2.0 mm 16.4 2.4 mm 16.5 3.2 mm 16.6...
-
Page 6: Application
Application Neutrix is manufactured to offer the following options: ! Grinding of oxidated or pure tungsten electrodes. ! Grinding electrodes with diameters from 1,0 – 4,0 mm. ! Variable angle adjustment from 15° to 180°. ! If it is necessary to grind electrodes shorter in length than 15mm–... -
Page 7: Before Use
(15) to the motor. How to select grinding position With the Neutrix it is possible to select 3 different grinding positions ! Unscrew the knurled wheel (22) ! Lift the eccentric plate (20) and turn through 90° to the next position, place the eccentric plate back in the slide of the angle adjustment. -
Page 8: Selection Of Electrode Diameter
! Adjust the machine speed according to the recommendations on page 8. ! Select the electrode clamp to suit the tungsten to be ground. How to operate Neutrix ! Place the tungsten electrode in the electrode holder (5) with approximately 35 mm protruding. -
Page 9: How To Grind The Electrode
How to grind the electrode ! Turn the electrode holder, whilst pushing the electrode against the diamond wheel. Do not push too hard in order to avoid blueing of the electrode. This can be viewed through the inspection cover ! The grinding is completed when the stop of the electrode holder (14) touches the end face of the electrode holder guide (6). -
Page 10: Maintenance:
Maintenance Remove the plug from the power supply before carrying out any maintenance or repairs. Replacing the filter The filter has to be changed when the amount of dust makes it difficult to watch the grinding process through the inspection cover (29). Loosen the allen screw (25.3) at the filter housing (25). -
Page 11: Parts Diagram
Parts diagram:- Page 11... -
Page 12: Parts List
Spring 1 piece N-44510310 Rubber seal big 1 piece N-44510320 Screw to fix filter cassette 4 pieces N-44510330 Sticker „Neutrix“ 1 piece N-44510340 Safety sticker 1 piece N-44510350 Degree scale 1 piece N-44510360 Screw to fix diamond wheel (M 8, SW 13)
Need help?
Do you have a question about the Neutrix and is the answer not in the manual?
Questions and answers