Advertisement
Quick Links
Li-ion rechargeable battery charger and analyzer
SETUP
1.
Before start, you need to prepare following :
1.1 Connect 3 push buttons to J5 using the 4-wire connector provided.
1.2 Prepare battery holder (NOT provided) for 2 cells with independent channel. Each channel MUST be
electrical isolated from the each other.
2.
Before turn on the power, connect above items as following diagram.
BLACK
Push
buttons
X3
Normal
OFF
Current
*
If the thermistor is not connected, the temperature shown will be <0°C and <32°F. This will not
affect the normal operation, but lose the thermal shutdown protection.
P 1 of 2
Jamestronic CHGR801
Quick Setup Manual
Thermistor *
+
+
CH1
CH2
-
-
BLACK
1
2
3
Start/
Mode
Display
AC to DC
Power Supply
Output 6V, >=2A
4
Heat sink for Q1-4 must be installed during
operation. Overheat will damage the devices !
AC 100-240V
center pin
POSITIVE
0807 Ver701
Advertisement
Summary of Contents for Jamestronic CHGR801
- Page 1 Jamestronic CHGR801 Li-ion rechargeable battery charger and analyzer Quick Setup Manual SETUP Before start, you need to prepare following : 1.1 Connect 3 push buttons to J5 using the 4-wire connector provided. 1.2 Prepare battery holder (NOT provided) for 2 cells with independent channel. Each channel MUST be electrical isolated from the each other.
- Page 2 Before turn on the AC power, check again for correct wiring. Turn on the power. The display will show the version number and temperature for 3 seconds. Then it will show “NO CELL” for both channels. OPERATION Insert a Li-ion rechargeable battery into either Channel 1 or Channel 2. The display will show “Charge ?”, asking for operation mode.