Advertisement
Using the AC/DC Power Supply
Connect the cable from the AC/DC power
supply to the Signal Booster input marked
"Power" and insert the plug end into a
surge protected AC Power Strip with at
least a 1000 Joule rating.
IMPORTANT: Connect both the
Outside and Inside Antenna cables to
the Signal Booster before powering up
the Signal Booster.
© Copyright 2014 zBoost, LLC. All rights reserved.
Rev.1 04.08.14
INSTRUCTION SHEET FOR
L-WINDOW BRACKET AND
AC/DC POWER SUPPLY
These instructions cover the antenna window
L-bracket and AC/DC power supply for use
with zBoost Mobile1 Signal Boosters.
For complete Signal Booster installation
instructions, please refer to the Installation
Guide packaged with the Signal Booster.
If you have any questions, please contact zBoost
Technical Support at 877-594-5766 or email
Support@zBoost.com
Advertisement
Table of Contents
Summary of Contents for zBoost ZB246
- Page 1 Signal Booster before powering up instructions, please refer to the Installation the Signal Booster. Guide packaged with the Signal Booster. If you have any questions, please contact zBoost Technical Support at 877-594-5766 or email Support@zBoost.com © Copyright 2014 zBoost, LLC. All rights reserved.
- Page 2 Installing the Window Bracket For the best possible performance, choose a location within the building where the existing signal is the strongest. Then select a nearby window at least 12 inches away from any Window Bracket radio or television antennas and free of &...
Need help?
Do you have a question about the ZB246 and is the answer not in the manual?
Questions and answers