Powermate PP0100363 Owner's Manual

Powermate PP0100363 Owner's Manual

Hide thumbs Also See for PP0100363:

Advertisement

Quick Links

PP0100363 / PP0100365
Water Pumps
Owner's Manual
000789
MODEL:________________________
SERIAL:________________________
DATE PURCHASED:______________
Register your Powermate
®
product at:
WWW.POWERMATE.COM
800-445-1805
SAVE THIS MANUAL FOR FUTURE REFERENCE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PP0100363 and is the answer not in the manual?

Questions and answers

Summary of Contents for Powermate PP0100363

  • Page 1 PP0100363 / PP0100365 Water Pumps Owner’s Manual 000789 MODEL:________________________ SERIAL:________________________ DATE PURCHASED:______________ Register your Powermate ® product at: WWW.POWERMATE.COM 800-445-1805 SAVE THIS MANUAL FOR FUTURE REFERENCE...
  • Page 2: Table Of Contents

    Table of Contents Section 1 Introduction and Safety Preventing Water Hammer ....9 Introduction ........1 Water Pump Shut Down ....9 Safety Rules ........1 After Each Use ......10 Safety Symbols and Meanings ..2 Exhaust Hazards ......2 Section 4 Maintenance and Fire Hazards ........
  • Page 3: Section 1 Introduction And Safety

    Section 1 Introduction and Safety Introduction DANGER ® Thank you for purchasing a Powermate Indicates a hazardous situation which, if not avoided, will product. This equipment has been designed to result in death or serious injury. provide high-performance, efficient operation, and years of use when maintained properly.
  • Page 4: Safety Symbols And Meanings

    Safety Symbols and Meanings WARNING DANGER Recoil Hazard. Recoil could retract unexpectedly if water pressure is not properly relieved from Asphyxiation. Running engines produce carbon pump, creating kickback. Kickback monoxide, a colorless, odorless, poisonous gas. could result in death or serious injury. (000113) Carbon monoxide, if not avoided, will result in death or serious injury.
  • Page 5: Fire Hazards

    When Operating Equipment • This exhaust system must be properly maintained. Do nothing that might render • NEVER place discharge hose near a power exhaust system unsafe source. noncompliance with any local codes and/or • Do not allow children near the pump while it standards.
  • Page 6: Section 2 General Information And Setup

    Fuel Cap Save this manual for future and immediate reference. Replacement owner’s manuals are Muffler available at www.powermate.com. Air Cleaner (Inside Cover) This pump is designed to pump clear water only. Do not use for pumping the following: Spark Plug •...
  • Page 7: Emissions Information

    Delivery Volume 158 USG/min (600 L/min) 260 USG/min (984 L/min) Maximum Suction Head 23 ft (7.01 m) * Engine Specifications Model Powermate Air-Cooled 4-Stroke OHV Single Cylinder Exhaust Volume 10.9 in (179 cc) Output Power 6.0 HP (4.47 kW) Fuel...
  • Page 8: Add Engine Oil

    Add Engine Oil Add Fuel CAUTION DANGER Explosion and Fire. Fuel and vapors are extremely Engine damage. Verify proper type and quantity of flammable and explosive. Add fuel in a well engine oil prior to starting engine. Failure to do so could result in engine damage.
  • Page 9: Assembly

    Consult Manual. Read and understand manual completely before using product. Failure to completely understand manual and product could result in death or serious injury. (000100a) ® Call Powermate Customer Service at 1-800- 445-1805 assembly issues concerns. Please have model and serial 000814 number available.
  • Page 10: Section 3 Operation

    Section 3 Operation Operation and Use Questions NOTE: Suspend the strainer if there is any mud or sand present at the bottom of the ® Call Powermate Customer Service at 1-800- water. 445-1805 with questions or concerns about • Place...
  • Page 11: Starting The Engine

    Starting the Engine 6. Grasp recoil handle (E) and pull slowly until you feel some resistance. Then pull CAUTION rapidly to start engine. Return recoil handle slowly. DO NOT let recoil snap Equipment damage. Before starting engine, verify back against recoil housing. pump is primed with water and suction strainer is 7.
  • Page 12: After Each Use

    After Each Use After cooling, remove the priming plug (A) and drain plug (B) from the pump housing and allow it to drain thoroughly. 000824 Figure 3-13. Draining Pump Housing NOTE: DO NOT allow water to remain in pump after use. Trapped water can freeze and crack the pump housing.
  • Page 13: Section 4 Maintenance And Troubleshooting Maintenance Recommendations

    Section 4 Maintenance and Troubleshooting Maintenance Recommendations Preventive Maintenance Regular maintenance will improve Dirt or debris can cause improper operation performance and extend water pump life. See and equipment damage. Clean water pump an Authorized Dealer for service. daily or before each use. Keep area around and behind muffler free from combustible Water pump warranty does not cover items debris.
  • Page 14: Inspect Engine Oil Level

    Inspect Engine Oil Level Change Engine Oil WARNING WARNING Accidental start-up. Disconnect spark plug wires when Risk of burns. Allow engine to cool before draining working on unit. Failure to do so could result in death or oil or coolant. Failure to do so could result in death serious injury.
  • Page 15: Service Air Cleaner

    (D). 4. Inspect both filter elements and replace if damaged. To order replacements, contact Powermate® Customer Service at 1-800- 445-1805 for the name of your nearest Authorized Service Center. 5. Clean foam filter element in warm soapy water.
  • Page 16: Check/Adjust Valve Clearance

    the exhaust system is equipped with a spark If fuel stabilizer is added to fuel system, prepare and run engine for long term storage. arrestor, defined Section 4442, Run engine for 10-15 minutes to circulate maintained in effective working order. Other stabilizer throughout fuel system.
  • Page 17: Troubleshooting

    Troubleshooting PROBLEM CAUSE CORRECTION Engine will 1. Dirty air filter 1. Clean or replace air filter. not start, or 2. Out of fuel. 2. Fill fuel tank. starts and 3. Stale fuel. 3. Replace with fresh fuel. runs rough. 4. Spark plug wire not connected to 4.
  • Page 18: Troubleshooting Procedures

    Troubleshooting Procedures See Figure 4-11. Verify suction hose is not flat anywhere along its length (A). Holes or cracks (B) will also affect suction. Finally, confirm that Cleaning The Impeller the suction hose is connected correctly. See Figure 4-9. The impeller (A) is located inside the volute casing (B).
  • Page 20 Rev. B 7/16/15 S45 W29290 Hwy. 59 Printed in USA Waukesha, WI 53189 ©2015 Powermate LLC. All rights reserved 800-445-1805 Specifications are subject to change without notice. powermate.com No reproduction allowed in any form without prior written consent from Powermate LLC.

This manual is also suitable for:

Pp0100365

Table of Contents