Connection And Installation - Velleman VWS2E Manual

6. Connection and Installation

1. Connecting your VWS2E to a DVR
1. DVR baud rate and ID setting: Set the baud rate and ID of the DVR. Make sure that the baud rate and ID are
identical to the settings of your VWS2E.
2. DVR and video web server pin connections: Connect the pins of the DVR to the pins of the VWS2E.
For detailed pin connection, refer to "Appendix 1" and "Appendix 2".
• PIN 1, 6: RS485-A, RS485-B
Use the RS485-A and RS485-B serial communication signals to control the digital units.
• PIN 4, 9: ALARM INPUT
Use pins 4 and 9 to receive the alarm input and to trigger the VWS2E to send an automatic notification mail to the
users.
• PIN 5: GROUND
• PIN 2, 3: NORMAL OPEN, NORMAL COM
Use pins 2 and 3 to trigger an external device.
It is recommended to solder the joints.
2. Software Installation
Place the CD into the CD-ROM. It will automatically start the installation application onto your PC. Click the
icon twice. Click the FINISH button to complete the setup. You will see the
your desktop.
3. IP Setting and LAN Connection
1. Set up the PC network: Click Start
→
Connections Local Area Connection Status
VWS2E
→ →
Control Panel
→
Properties
- 3 -
Network and Internet Connections
→
Internet Protocol (TCP/IP)
("Video Server E") icon on
→
Network
VELLEMAN