Table of Contents
Advertisement
Preparing and using the remote control
Loading dry-cell batteries
into the remote control
q Remove the battery cover.
w Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
Two batteries (LR06, SIZE AAA) are
used.
e Replace the battery cover.
(1)
(2)
Dry-cell batteries
• Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries with
new ones.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
Operating the remote
control
Point the remote control toward the
projector's infrared remote sensor,
and press a button on the remote
control.
• Operating the projector from the front
Approx. 15°
• Operating the projector from the rear
Approx. 15°
18
Switching operation modes
Operation modes should be switched between projector operation and computer operation.
Switching the remote control operation mode.
Pressing this button toggles the mode.
When this button is lit, the remote control is in [PJ Mode]
(Projector operation mode).
If no operations are made for 30 seconds, this light goes
out, and the remote switches back to [PC Mode] (Computer
operation mode).
[PJ Mode] : Functions as a select button.
[PC Mode] : Functions as a mouse pointer control.
PJ MODE
ENTER
[PC Mode] : Functions as a down button. Used to go back
R-CLICK
RETURN
ESC
[PC Mode] : Functions as an up button. Used to go forward
INPUT
SET UP
MENU
[PJ Mode] : Functions as a ENTER button.
FREEZE
[PC Mode] : Functions as the right mouse button (R-CLICK).
[PJ Mode] : Functions as a RETURN button.
[PC Mode] : Functions as a ESC button.
Pressing one of these buttons automatically sets the remote
control to [PJ Mode].
If no operations are made for 30 seconds, and the remote
switches back to [PC Mode].
The L-CLICK (left click) button on the back of the remote
control functions when in [PC Mode].
Note
• With the exception of operating a PC with the remote control, all buttons are used in [PJ
Mode].
If no menu is displayed, adjusts volume.
on Microsoft
®
PowerPoint
®
slides, etc.
®
®
on Microsoft
PowerPoint
slides, etc.
19
Advertisement
Table of Contents
