Download Print this page
Duke FLM 100 Instruction Sheet
Duke FLM 100 Instruction Sheet

Duke FLM 100 Instruction Sheet

Retro fit half rack split

Advertisement

Quick Links

FLM 100 Retro Fit Half Rack Split
In this package, you are receiving an upgrade kit for your front line bread display cabinet intended to
enhance the hold time of bread in the cabinet. Included are instructions to install the upgrade kit.
When holding bread in the display cabinet, holding full batches and rotating product will yield the
best results.
Lastly, if your restaurant utilizes a Flexbake5 All in One oven, there is an updated recipe that will need
to be loaded into your oven. The recipe changes are as follows:
Full Bread & Full Bread w/Cheese Recipes:
Stage 1:Change "stage time" to 18 minutes, "humidity time" to
18 minutes, and "H20 on Time" to 1.
Stage 2: Change "stage time" to 6 minutes
Stage 3: Change "H2O on Time" to 1
*all other values will remain as is
Half Bread & Half Bread w/Cheese Recipes:
Stage 1:Change "stage time" to 18 minutes, "humidity time" to
18 minutes, and "H20 on Time" to 1.
Stage 2: Change "stage time" to 6 minutes
Stage 3: Change "H2O on Time" to 1
*all other values will remain as is
Should you have any questions during the installation of your
upgrade kit or with programming the updated Flexbake5 All in
One oven recipes, please call our technical service team at: 1-800-
735-3853 ext. 1.
Regards,
Your Team and Duke Manufacturing
1-800-735-3853
www.dukemfg.com/Subway
CAUTION:
Please read these instructions completely before attempting
to install, operate or service this equipment.
WARNING: Cancer and Reproductive Harm -
www.p65warnings.ca.gov
This manual is Copyright © 2019 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
Instruction Sheet
REV C 08/26/2019
P/N 2503963

Advertisement

loading
Need help?

Need help?

Do you have a question about the FLM 100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Duke FLM 100

  • Page 1 WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov This manual is Copyright © 2019 Duke Manufacturing Co. All rights reserved. Reproduction without written permission is prohibited. Duke is a registered trademark of the Duke Manufacturing Co.
  • Page 2 Installation and Operation of: FLM100 Half Rack Retro INSTALLATION Tools Required: Parts Included: • Partition Plate, • Edge Trim Gasket, Phillips Head Screwdriver • Aluminum Strip with Adhesive • Alcohol Pads Dry Erase Pen Please read these instructions completely before attempting to install, operate or service this equipment.
  • Page 3 Installation and Operation of: FLM100 Half Rack Retro INSTALLATION - continued Step 7 Step 8 Step 11 With the door closed, place Open the door. Take the Close the door and verify that the the non-adhesive side of the Aluminum strip with the double aluminum strip makes contact aluminum strip against the glass sided tape and peel off the...
  • Page 4 Step 15A Level Unit front to back on both sides. NO GAP RE-ADJUST UPDATE - COMPLETE Phone: 314-231-1130 Duke Manufacturing Co. Toll Free: 1-800-735-3853 2305 N. Broadway www.dukemfg.com Fax: 314-231-5074 St. Louis, MO 63102...