Related Manuals for ACTi PMAX-0305
Summary of Contents for ACTi PMAX-0305
- Page 1 Indoor PTZ Mounting on a Corner Wall Using Accessory Sets Installation Guide For Models: I91, I92, KCM-8111 2013/12/09...
-
Page 2: Table Of Contents
Step 3: Install the Mount Kit (PMAX-0110) ..........7 Step 4: Install the Camera ................. 8 Step 5: Access the Camera Live View ............9 Appendix ................10 How to Install Extension Tubes .............. 10 Safety Information ............11 www.acti.com... -
Page 3: Mounting Accessory Set Solution
The mounting accessory set below can be used to install the camera on a vertical pole. Must Drill Cable Mounting Solution Cabling Solution Hole on the Wall Corner Mount with Heavy Cable goes along the wall. Duty and Mount Kit Installation Procedures (SMAX-0042) PMAX- 0402 PMAX-0305 PMAX-0110 www.acti.com... -
Page 4: Corner Mount With Heavy Duty And Mount Kit Installation Procedures
2. Drill the eight (8) screw holes. 3. Attach eight (8) screws (not included in the package) to secure the Corner Mount to the wall. NOTE: Purchase screws applicable to the wall type you are mounting the Corner Mount to. www.acti.com... - Page 5 Installation Guide 4. Route the network cable and other cables (if any) through the conduit hole of the Corner Mount. www.acti.com...
-
Page 6: Step 2: Install The Heavy Duty Mount
2. Attach the Heavy Duty Mount on the Corner Mount using the four (4) screws (included in the Corner Mount package). Optional: Add Extension Tube(s) If the Heavy Duty Mount is not long enough, add one extension tube (purchased separately). See How to Install Extension Tubes on page 10. www.acti.com... -
Page 7: Step 3: Install The Mount Kit (Pmax-0110)
For more information on connecting the terminal blocks, refer to the camera model Hardware Manual downloadable from the website (www.acti.com). 1. Insert the cable(s) from the Heavy Duty mount into the mount kit and route them to pass through the outer bracket. -
Page 8: Step 4: Install The Camera
(included in the mount kit package) to easily route the cables because of its flexibility. 3. Align and insert the camera base hooks to the mounting holes. 4. Slide the camera counter-clockwise to secure the hooks to the mount. www.acti.com... -
Page 9: Step 5: Access The Camera Live View
5. On the top of the mount kit, attach the three (3) screws (included in the mount kit package) to secure the camera to the mount. The final installation would look similar to the one below: Step 5: Access the Camera Live View Refer to the camera Hardware Manual downloadable from the website (www.acti.com) for more information. www.acti.com... -
Page 10: Appendix
3. Align the slot on the extension tube to the tab inside the Heavy Duty Mount and install the extension tube. Cable With Flex Conduit Cable without Flex Conduit 4. Twist the extension tube to align the screw holes and reattach the two (2) mounting screws removed from step 1 www.acti.com... -
Page 11: Safety Information
Do not use attachments not recommended by the video product manufacturer as they may cause hazards. Do not use accessories not recommended by the manufacturer Only install this device in a dry place protected from weather Servicing Do not attempt to service this video product yourself. Refer all servicing to qualified service personnel. www.acti.com... - Page 12 Safety Check Upon completion of any service or repairs to this video product, ask the service technician to perform safety checks to determine if the video product is in proper operating condition. www.acti.com...
Need help?
Do you have a question about the PMAX-0305 and is the answer not in the manual?
Questions and answers