Toshiba TDP-B1 Owner's Manual page 33

Toshiba owner's manual projector

Hide thumbs Also See for TDP-B1:

Table of Contents

6 Lift and grasp the pull tab and lift the module out (Figure 21).

7 Install the new lamp module, being sure to align the connec-

tors properly.

8 Push the module in until it is flush with the bottom case of the

projector.

9 Tighten the screws on the outside of the module.

10 Replace the lamp door by inserting the hooks on the rear of

the lamp door into the projector and pressing the lamp door

into place. If the lamp door does not fit properly or bulges out,

remove the door and re-seat the lamp module.

11 Plug in the power cord to turn the projector back on.

12 To reset the lamp hour counter in the Status window, press

and hold the

volume -

(while still holding down the

Verify that the counter was reset by pressing the

and viewing the counter in the Status window.

button, then press the

button) for 5 seconds.

volume -

pull tab

IGURE

Removing the lamp module

button

WARNING: Do not drop the

lamp module or touch the glass

bulb! The glass may shatter and

cause injury.

Table of Contents

Troubleshooting