Würth KV5700 Assembly, Mounting And Installation Instructions
Würth KV5700 Assembly, Mounting And Installation Instructions

Würth KV5700 Assembly, Mounting And Installation Instructions

Keyboard tray

Advertisement

Quick Links

KV5700 Keyboard Tray
Carton should contain the keyboard tray subassembly and a hardware kit consisting of:
4- #8 x
1
" self tapping screws
4
8- #8 x
5
" mounting screws
8
4- Adjustable mounting brackets with 7 position slots
Knape & Vogt Manufacturing Company guarantees its drawer slides and builder's hardware products
against failure or defects for so long as the purchaser or end user own them. This warranty is void if any
damage to the product is due to misuse, abuse, neglect, accident, improper installation or any used con-
trary to the instructions accompanying the product. This warranty covers the cost of the defective part
and not the cost of removal, installation or other incidental charges. The foregoing are the purchaser's
exclusive remedies. Knape & Vogt Manufacturing Company, Attention: Customer Services Department.
The warranty set forth above is in lieu of any other warranties, express or implied, including warranties or
merchantability and fitness for use.
Limited Lifetime Warranty

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KV5700 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Würth KV5700

  • Page 1 KV5700 Keyboard Tray Carton should contain the keyboard tray subassembly and a hardware kit consisting of: 4- #8 x ⁄ " self tapping screws 8- #8 x ⁄ " mounting screws 4- Adjustable mounting brackets with 7 position slots Limited Lifetime Warranty Knape &...
  • Page 2 Assembly, Mounting and Installation Instructions Step 1. Keyboard Preparation (Optional) It is recommended, but is not required, to disassemble the slides from the tray for easier installation. This is easily done by first depressing the plastic lever as shown in Figure 1 and then pulling the slide members apart.
  • Page 3 Step 5. Surface Preparation Depending on whether the bracket direction is inward or Align and outward- Use the dimensions provided on this sheet to insert tray. layout the hole locations on the surface before drilling. Drill 4 pilot holes, for #8 x 5/8" screws, into the underside Pull forward.

Table of Contents