GSL MCM Operating Instructions

Model:
MCM
Page 1 of 4
The MCM unit unleashes the full potential of the multi award winning
Using this simple plug and play option allows a display of the solar

Safety

• Read all instructions and cautions in the manual before installing and operating the MCM
• There are no user serviceable parts inside the MCM, do not disassemble or try to repair the unit.
• Install the unit in a dry place out of direct sunlight and away from flammable liquids or gasses.
• Do not use the MCM if the enclosure or wires are damaged.

MCM Connection

First install the MPPT30-2 or MPPT60-2 unit as per their own user manual. Confirm that the MPPT is functional
via the built in output status led, it should be green. Plug the MCM via the 9 pin D connector on the MPPT from
panel and the system is ready to go. The MCM should be on the default screen displaying battery voltage,
battery current, load current and temperature.
The optional MCM PC GUI software, enables detailed system information storage and display on spreadsheet
format as well as remote monitoring and control over the internet. This optional software is available with the
MCM v200 and higher.
D9 Connector Cable
Point Tracker Monitor
GSL MPPT Solar Battery Chargers.
system parameter as well as alarm settings.
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Maximum Power
Operating Instructions
Please Read Before Use
MCM Unit
Optional:
USB Connector Cable
MCM-R5