Belltech OND-9005 Manual

OND-9005 ALARM DIALLER

GENERAL

OND-9005 is an alarm dialler that upon activation by a radio remote control or
by wire will dial up to 14 different telephone numbers and then announce a fixed
recorded messages that can be partly selected by the end-user. The calling will
continue until being acknowledged by the receiver pressing a digit sequence on
his telephone (DTMF).
The message will be repeated up to 8 times waiting for acknowledgement for
each receiver. If no acknowledgement it will disconnect and dial the next
programmed telephone number. After dialling each telephone number 16 times
it will give up, and make indication by the red LED.
The alarm dialler will in the pre-recorded speech identify itself using a digit 1-9
(ID code) as set by the user.
For activation by wire there are two alarm inputs (A and B).
For activation by remote control this is Alarm A
The alarm dialler is powered from the AC mains (230V / 50Hz) or from 12V
DC (as alternatively can be used for backup).
Speech (kommer att vara på engelska):
<MEDDELANDE FRÅN LARMSÄNDARE>
<Meddelar larmsändarens nr 1,2,3,...9, om satt 0 utgår denna information>
<LARM A eller LARM B eller LARM A LARM B>
<VIDTAG ÖVERENSKOMNA ÅTGÄRDER>
< Om kvittering: KVITTENSEN ÄR MOTTAGEN LÄGG PÅ LUREN>
During the alarm the AC output (relay) will be activated during a pre-set timing.
1