Andrew ValuLine Installation Instructions

Installation Instructions
0.2m(20cm), 0.3m(1ft) & 0.6m(2ft)
ValuLine Antenna Mount
Description
This antenna consists of a 0.2-metre(20cm)/
0.3-metre (1ft)/ 0.6-metre (2ft) reflector,
radome, feed and offset tower mount.
The mount is designed to attach the antenna
to a vertical pipe of diameter 48-115mm
(1.9-4.5").
The mount also provides adjustment in the
ranges of ±25° fine elevation and
±180° (±10° fine) azimuth.
Notice
The installation, maintenance, or removal of
antenna systems requires qualified,
experienced personnel Andrew installation
instructions have been written for such
personnel. antenna systems should be
inspected once a year by qualified
personnel to verify proper installation,
maintenance and condition of equipment.
Andrew disclaims any liability or
responsibility for the results of improper or
unsafe installation
practices.
1
1
0.3m (1ft) Application
(Single Pole version shown)
Andrew Wireless Solutions
Customer Service 24 hours
U.S.A., Canada, Mexico: 1-800-255-1479
or 1-888-235-5732
U.K.: 0800 250055
Other Europe: +44 592 782 612
Notice: Andrew disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: Andrews no acepta ninguna obligacion ni responsabilidad como resultado de practicas incorrectas o peligrosas de instalacion, inspecci6n, mantenimiento o retire.
Avis : Andrew decline toute responsabilite pour les consequences de procedures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: Andrew lehnt jede Haftung Oder Verantwortung fur Schaden ab, die aufgrund unsachgemaBer Installation, Uberprufung, Wartung Oder Demontage auftreten.
Atencao: A Andrew abdica do direito de toda responsabilidade pelos resultados de praticas inadequadas e sem seguranca de instalacao, inspecao, manutengao ou remocao.
Awertenza: Andrew declina eventual! responsabilita denvanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
2
www.andrew.com
Visit our Web site at www.andrew.com or contact your local Andrew Wireless Solutions representative for more information.
© 2008 CommScope, Inc. All rights reserved.
Andrew Wireless Solutions is a trademark of CommScope. All trademarks identified by ® or ™ are registered trademarks or trade-
marks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement any
specifications or warranties relating to Andrew Wireless Solutions products or services.
Andrew Institute offers installation training.
2
Apply loctite (8)
to threads
before fitting
to antenna
10
7*
7*
DO NOT REMOVE
PROTECTIVE CAP
DURING MOUNT
INSTALLATION
Bulletin 102222
Version 03 Status RE Rev
A CommScope Company
Bulletin 102222
page
03
Version Status RE
Model Version 01 Status RE
3
2
10
When fitting
hand tighten nuts
evenly and torque
nuts (4) to
22Nm (16.2lb-ft)
6
5
4
E
1 of 2
Rev G
Rev B