Optimum VIBE User Instructions

OPTIMUM VIBE PROGRAMMABLE THERMOSTAT - USER INSTRUCTIONS

Touch-sensitive buttons:

Transmitter

Temporary override using the UP and DOWN arrow icons.

Whilst in program mode (display shows PRG in the top-right) , you can adjust the set temperature by touching
the UP or DOWN arrows. This is a temporary override of the current temperature setting. The display will
change from showing 'ROOM' and the current measured temperature, to showing 'SET' and the temperature
that you are now setting. Five seconds after you have changed the temperature to the value you want for the
time-being, the thermostat will 'time-out' and once again show 'ROOM' and the measured temperature. The
heating will be switched ON or OFF according to the adjustment you have made. The programmed time / tem-
perature setting will be restored with the next program entry in the memory.
Permanent override—manual mode using the SET icon
SET
In the program run mode, touch the SET icon briefly to choose between Program mode (PRG) or manual mode
(sun symbol ). In manual mode you can set a different temperature from the programme. Manual mode is a
permanent selection which will only change if you touch the SET icon again. Program mode (PRG) runs the pro-
grammed time & temperature sequence.
Set the time & weekday:
SET
Insert the batteries with correct polarity. The screen will jump to time-setting mode. Or—during normal opera-
tion, touch the SET icon for 5 seconds to go into time-setting mode. Using the UP and DOWN arrow icons you can
set the current time—you must also set the weekday. Whether you change a value or not, touch the SET icon to
confirm and move on to the next setting. Go back to run mode by pressing ON/OFF or BACK, or the VIBE will
'time-out' to run mode after about ten seconds.
Transmitter and receiver display / controls
Current program number
Weekday indicator
Current time
0
Temperature
Set temperature—during programming or when manually changing
Room temperature (default temperature display)
switch on or off
PROG to programme
SET to select pre-set temperatures
increase / decrease temperature
back icon to go back
Manual mode
Program mode
PROG
SET
C
Heat demand indicator
Receiver
VIBE
ON/OFF
UP
PROGRAM
DOWN
SETTINGS
BACK
operate the receiver
manually
switch the receiver
on or off
OVERRIDE
(short press)
RF LINK
(long press)
Heating on
ON/OFF
Power