Summary of Contents for Vantly BT-1228SDU-S
- Page 1 Dual Function Trailer Manual ATTENTION: Please read this instruction before mounting and using. Disregarding the directions in this manual can cause damage or injury. ...
- Page 2 Model no. BT-1228SDU-S Before you start assembly, please check the contents of the carton: ♦ 1 x trailer folded ♦ 1 x 8” front swivel wheel set ♦ 2 x 20” rear wheel ♦ 1 x handlebar ♦ 1 x tow bar ♦...
- Page 3 Step 3: Step 4: Pull the rear tubing backward. (The buckles might hit the Close the both side clips. The red lever will fall and set seat back, push the seat back forwarder to let the automatically. buckles pass through it.) Step 5: Step 6: Closed the zippers at both sides of fabric cover after both...
- Page 4 Step 9 : Step 10: Pull down the side protect bar at both sides of trailer. Fasten the lever of the qulick release and the tow bar is now secured. Step11: Step 12: The ball pin at front side would be fell into bracket To assemble the trailer with your bike.
- Page 5 Step 15: Step 16: Circle the safety strap around the rear stay of bicycle and The entrance for child to come in and get out is the hook it back to the tow bar. zipper door. Step 17 : Step 18 : When the child is in the trailer.
- Page 6 Step 21: Push the rear tubing forward. Then the trailer could be folded. Change the trailer to the baby stroller (function 2) Step 1 : Step 2: Insert the 8” front swivel wheel into bracket located at When using the trailer as the stroller function, must assemble the front of the trailer.
- Page 7 Parking device- packing device should be engaged when placing and removing the children Step 1 : Step 2: The brake system is at rear side. To set the parking brake, Make sure the brake shaft insert into the both side press the brake bar down into the locked brake gears exactly.
- Page 8 Instruction of safety belt. WARNING! Always adjust the shoulder harness and crotch strap so that they meet at the child’s lower chest. Adjusting harness and buckles near your child’s neck could cause serious injury. ONE CHILD 1. Unclip the right-hand shoulder harness from the 2 safety lock buckle.
- Page 9 SATETY NOTES/WARNING!: 1. This product is two functions, one is trailer function, the other is stroller function, when using as trailer, the front wheel must not be mounted at the trailer nor left into the trailer. 2. Maximum load = 42kgs(baby:18kgs+baby:18kgs+luggage:6kgs). 3.
- Page 10 1. Black connector 13. Sleeve(2pcs)&bearing(2pcs) 25. Rear wheel bushing(2pcs) 2. Silver alloy tubing 14. Screw bolt 26. 20” Rear wheel(2pcs) 3. Locking clip 15. Front wheel axle 27. Safety pin(2pcs) 4. Nut (2pcs) 16. Front fork 28. Brake bracket(2pcs) 5. Washer (2pcs) 17.