Advertisement
Preparation
1. Push the LOCK towards the direction shown to
release the transmitter (fig. 1)
2
1
fig. 1
3. Remove the screw
on the Hovercraft
base as illustrated
(fig. 3)
5. Insert and tighten the antenna to the antenna
hole on the transmitter as illustrated (fig. 5)
2
1
POWER
OFF
fig. 5
7. Move the ON/OFF switch on the
remote controller to ON.
Leftward
The power LED lights up (fig. 7)
8. Move the ON/OFF switch on the Hovercraft to OFF. Open the charger cover on
the remote controller and take out the charging cable.
Insert the charging plug into the charging socket
on the Hovercraft (fig. 8).
The red charge LED lights up
(charging in process, fig. 9)
and will extinguish after
12 minutes (charged).
CHARGE
POWER
OFF
ON
fig. 3
CHARGE
ON
POWER
OFF
fig. 8
2. Remove the cover and take
out the antenna (fig. 2)
4. Turn the retaining screws
anticlockwise (fig. 4)
6. Use a Phillips screwdriver to open the battery
compartment cover. Insert 4 x AA batteries with the correct
polarity and replace the battery compartment cover (fig. 6)
fig. 6
CHARGE
Power LED
ON
fig. 7
POWER
OFF
6
1
2
fig. 4
CHARGE
POWER
OFF
ON
CHARGE
Charge LED
ON
fig. 9
fig. 2
Advertisement
