Self-Propelling The Machine; Shutting Off The Engine; Operating The Quick Stick; Clearing A Clogged Discharge Chute - Toro SnowMaster 724 QXE Operator's Manual

Self-Propelling the Machine

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine automatically keeps pace with
you (Figure 15).
Note:
You can self-propel the machine with the auger
engaged or disengaged.
Figure 15

Shutting Off the Engine

To shut off the engine, remove the key from the
ignition or move the key to the middle position.
Operating the Quick Stick®
Note:
Fully press the blue knob to release the latch
and operate the Quick Stick®.
g030119
Clearing a Clogged
Discharge Chute
WARNING
If the auger/impeller is running but there is no
snow coming out of the discharge chute, the
discharge chute may be clogged.
Never use your hands to clear a clogged
discharge chute. This could result in personal
injury.
1. While remaining in the operating position,
release the self-propel handle.
2. Engage the auger.
3. Push down on the handle to raise the front of
the machine a few centimeters (inches) off the
pavement, then lift the handles quickly to bump
the front of the machine onto the pavement.
4. Disengage the auger.
5. Repeat steps 1 through 4, if necessary, until
a stream of snow comes out of the discharge
chute.
12
Figure 16
g030118