MAPro VMX Three60 Manual

Marpo Kinetics, Inc.
258 LINDBERGH AVE, Livermore, CA 94551 • (925) 606-6919 • www.marpokinetics.com
- VMX Three60 –
IMPORTANT
INFORMATION
TO SAFELY REMOVE PRODUCT
FROM THE PACKAGE,
FOLLOW THESE INSTRUCTIONS
FOR SAFETY, TWO OR MORE PEOPLE MUST ASSIST IN THE PACKAGE
REMOVAL AND PRODUCT INSTALLATION.
IT IS BEST THAT THE REMOVAL OF THE PRODUCT FROM THE PACKAGE, BE
DONE NEAR THE AREA WHERE THE PRODUCT WILL BE PLACED FOR USE.
THIS WILL ELIMINATE THE NEED TO MOVE THE PRODUCT AROUND AFTER
IT IS ASSEMBLED. SHOULD THERE BE A NEED TO MOVE THE PRODUCT,
THERE MUST ALWAYS BE AT LEAST TWO PEOPLE DOING THIS OPERATION
TO AVOID ANY INJURIES. TO PROTECT THE ROPE FROM SNAGS, IT MUST BE
KEPT WRAPPED UNTIL IT IS READY TO BE STRETCHED ONTO THE PULLEYS.
REMEMBER, ALWAYS KEEP ALL BODY PARTS AWAY FROM PULLEYS OR ANY
MOVING PARTS AS THESE ELEMENTS CAN CAUSE SERIOUS INJURY.
MINORS SHOULD NEVER BE ALLOWED TO OPERATE THE MACHINE WITHOUT
THE CONSENT AND CONSTANT SUPERVISION OF AN ADULT.

Securing Equipment

All MARPO equipment must be secured to the floor to stabilize and eliminate rocking or
tipping. This must be performed by a licensed contractor. DO NOT use the equipment if it
is not set up and located on a solid, level surface.
DO NOT install equipment on an uneven surface.
Use fasteners having a minimum of 500 lbs. tensile capacity (3/8" grade 2 bolts or better).
If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or
frame not in contact with surface using flat washers.
1