WHAT'S INCLUDED
• USB 2.0 cable
• DC cable
• CD recording software—Nero 16 essentials
• User guide
• DVD/CD drive
FRONT DISPLAY
LED indicator
EJECT button
Manual ejection opening
REAR DISPLAY
USB 2.0 port
CABLE IDENTIFICATION
DC Plug
USB 2.0 cable
FEATURES
• Supports both 8cm and 12cm discs
• Supports all of the popular CD and DVD formats
• Multi-recorder for DVD±R/DVD±RW/CD-RW
• Supports hot swapping and plug-and-play functions
• Buffer underrun technology to prevent errors
• High-speed USB 2.0
EXTERNAL SLIM DVD/CD DRIVE
Instruction Manual
DC power jack
OPERATING INSTRUCTIONS
INSTALLING THE DRIVE
1. Plug the USB 2.0 connector into the device's rear USB 2.0 port.
2. Plug the DC plug into the device's rear DC power jack.
USB 2.0 plug
DC plug
TRAY OPERATION
Press the EJECTION button and the tray will automatically eject, allowing
you access to take or put in a disc.
TROUBLESHOOTING
Why is my USB 2.0 device reading, boot failure?
• Please make sure your disc is not scratched or bent
• Please make sure the version of BIOS supports booting from external
CD-ROM, if not, please upgrade your BIOS version
• The device does not support pure DOS mode
NOTE: Any improper procedures will affect the function of the com-
puter. Please read the user manual, or contact your computer provider
before use.
SYSTEM REQUIREMENTS
Windows 7/8/10
Interface: USB 2.0
NERO 16—SUPPORT
Windows 7 (32/64-bit)
Windows 8 (32-64-bit)
Windows 10 (32/64-bit)
NOTE: Nero software is for Windows based PC systems only.
READ SPEEDS:
8x DVD+R
8x DVD+RW
6x DVD+R Dual Layer
24x CD-R
24x CD-RW
8x DVD-ROM
24x CD-ROM
NOTE: LED light will blink when the device is reading and writing data.
sku 8014508
WRITE SPEEDS:
8x DVD+R
8x DVD+RW
6x DVD+R Dual Layer
24x CD-R
24x CD-RW
Need help?
Do you have a question about the 8014508 and is the answer not in the manual?
Questions and answers
I have installed Model 8014508D and then inserted a DVD but I cannot find where I can start the DVD on my screen.
To start a DVD on the Vital Model 8014508D:
1. Connect the drive to your computer using the USB 2.0 cable.
2. Insert a DVD into the drive (supports both 8cm and 12cm discs).
3. The drive supports plug-and-play, so your computer should recognize it automatically.
4. Use DVD playback software on your computer to start the DVD.
No additional installation is needed if your system supports plug-and-play.
This answer is automatically generated