Table of Contents
Advertisement
BATTERY INSTALLATION
NOTE: For the best performance, remove all of the factory-installed
batteries from the Scoop & Play Digger
alkaline batteries.
1. Make sure the unit is Off.
2. Locate the battery cover at the bottom of
the tray and open it with a screwdriver.
3. Install 2 new AA batteries following the
diagram inside the battery box. (New
alkaline batteries are recommended for
maximum performance.)
4. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
•
Use new alkaline batteries for maximum performance.
•
Use only batteries of the same or equivalent type as recommended.
•
Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
•
Do not use damaged batteries.
•
Insert batteries with the correct polarity.
•
Do not short-circuit the battery terminals.
•
Remove exhausted batteries from the toy.
•
Remove batteries during long periods of non-use.
•
Do not dispose of batteries in fire.
•
Do not charge non-rechargeable batteries.
•
Remove rechargeable batteries from the toy before charging
(if removable).
•
Rechargeable batteries are only to be charged under adult
supervision.
and install brand new
TM
4
4
4
Advertisement
Table of Contents
