Summary of Contents for REDSHIFT MIRAGE
- Page 1 MIRAGE User’s Manual V0.94 MIRAGE Manual V0.94 (Check o ur website for the latest version)...
- Page 2 MIRAGE Manual V0.94 (Check o ur website for the latest version)...
- Page 3 The MIRAGE does not operate on batteries. Bypass The MIRAGE features true-bypass switching. In any mode, the footswitch on the right side of the pedal functions as the bypass control. The LED next to this switch indicates the bypass state (ON = engaged, OFF = bypassed).
- Page 4 Whether or not a repeat is played in reverse in ‘reverse mode’ or an octave up in ‘octave mode’ depends on the pattern. This can be modified in the pattern editor. The MIRAGE can store up to 15 custom patterns. When turning the pattern selection knob, the selected pattern is indicated by the cluster of 4 LEDs.
- Page 5 Expression/CV Input The MIRAGE features a 3.5mm expression and CV combo input. Expression plugs must be TRS - T ip = Wiper Output, Ring = Input, Sleeve = GND . CV plugs must be TS (not TRS) - T ip = Voltage, Sleeve = GND.
- Page 6 Pre-gain/Attenuation - Internal DIP Switch The input gain/attenuation of the MIRAGE can be configured using a small DIP switch (labelled ‘Input Level’) located on the pedal’s circuit board. To access this switch, the back of the enclosure must be carefully removed. The DIP switch is quite delicate, use care when setting Many gain/attenuation settings are possible with this switch.
- Page 7 3) Connect your 9V power adapter to the MIRAGE. 4) Connect the MIRAGE to your computer with the Mini-USB cable provided ( N ote: The tip of the cable may protrude slightly when inserted, be careful not to force it).
- Page 8 Email: b en@redshifteffects.com Website: w ww.redshifteffects.com Instagram: @ redshifteffects MIRAGE Manual V0.94 (Check o ur website for the latest version)...
Need help?
Do you have a question about the MIRAGE and is the answer not in the manual?
Questions and answers