Gigabyte X570 I AORUS PRO WIFI User Manual page 26

& SMT Mode
Allows you to enable or disable the CPU Simultaneous Multi-Threading technology. This feature only works
for operating systems that support multi-processor mode. Auto lets the BIOS automatically configure this
setting. (Default: Auto)
& AMD CPU fTPM
Enables or disables the TPM 2.0 function integrated in the AMD CPU. (Default: Disabled)
& Extreme Memory Profile (X.M.P.)
Allows the BIOS to read the SPD data on XMP memory module(s) to enhance memory performance when
enabled.
Disabled
Disables this function. (Default)
Uses Profile 1 settings.
Profile1
Uses Profile 2 settings.
Profile2
(Note)
& XMP High Frequency Support
Allows you to select the compatibility level for high-frequency memory. This item is configurable only when
Extreme Memory Profile (X.M.P.) is set to Profile1 or Profile2. (Default: Auto)
& System Memory Multiplier
Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD
data. (Default: Auto)
ƒ Advanced Memory Settings
ƒ Memory Subtimings
d Standard Timing Control, Advanced Timing Control, CAD Bus Setup Timing, CAD Bus
Drive Strength, Data Bus Configuration
Allows you to set the memory timings. Note: Your system may become unstable or fail to boot after you
make changes on the memory timings. If this occurs, please reset the board to default values by loading
optimized defaults or clearing the CMOS values.
ƒ SPD Info
Displays information on the installed memory.
& CPU Vcore/Dynamic Vcore(DVID)/VCORE SOC/Dynamic VCORE SOC(DVID)/CPU VDD18/
CPU VDDP/DRAM Voltage (CH A/B)
These items allow you to adjust the CPU Vcore and memory voltages.
ƒ Advanced Voltage Settings
This submenu allows you to configure Load-Line Calibration level, over-voltage protection level, over-current
protection level, and PWM frequency.
(Note) This item is present only when you install a CPU and a memory module that support this feature.
(Note)
(Note)
- 26 -