Dampening Cylinder - Hardi FORCE Operator's Manual

8.7 Dampening Cylinder

The dampening cylinder on the FORCE™ boom is set at the factory
to "dampen the oscillation" from the boom suspension and normally
needs no adjustment. If adjustment is desired, use the following
procedure.
1. Loosen the jam nut (A)(Fig.41).
2. Screw the adjustment screw (B)(Fig. 41) in all the way. Then
back the adjustment screw out 2 turns.
3. If further adjustment is needed, turn adjustment screw "IN" to
increase dampening, or "OUT" to decrease dampening.
4. When desired adjustment is reached, tighten jam nut (A)(Fig. 41).
Note: The adjustment screw must be at least 1/4 turn out (from all
the way in) or seal damage may occur.
Fig. 41
HARDI
B
A
®
FORCE™ BOOM OPERATOR'S MANUAL 35