Dryco Pool Cover Drain Kit Manual

Hide thumbs

Thank you for purchasing the Dryco Drain Kit.

Unlike conventional pool covers, it is very important that you do not lower the water level in your pool before

installing the Dryco Drain Pool Cover. The water level must be kept higher than the inlet in the side of the pool.

If you are in an area where freezing conditions might occur, you will have to winterize your skimmer basket. There are

many ways to achieve this. You will need to consult your pool store to see which way is best for you. The Dryco Drain

does not protect your skimmer basket from freezing and possibly bursting.

Leaves may fall onto the cover. Normally, since the cover stays dry, the wind will blow the leaves off. If your cover

should collect leaves, you may use your pool brush with an extension pole to remove them.

After installing the Dryco Pool Cover Drain in your cover, please follow the

safety guidelines that come with the cover.

If the drain should collect leaves or debris, DO NOT ATTEMPT TO

CRAWL ON, LEAN ON OR REACH OUT OVER THE COVER TO

REMOVE IT. Use the pool brush with extension pole to remove them.

The Dryco Pool Cover drain is not intended to be used for any other

application other than installation in a pool cover.

Following these guidelines will ensure that you will enjoy the use of your Dryco Drain for many years to come.

Dryco Pool Cover

Drain Kit

Warning:

Table of Contents

Need help?

Do you have a question about the Pool Cover Drain Kit and is the answer not in the manual?

Questions and answers

Summary of Contents for Dryco Pool Cover Drain Kit

Page 1 If you are in an area where freezing conditions might occur, you will have to winterize your skimmer basket. There are many ways to achieve this. You will need to consult your pool store to see which way is best for you. The Dryco Drain does not protect your skimmer basket from freezing and possibly bursting.
Page 2 Installation Instructions for Dryco Pool Cover Drain Into Cover Step 1: Find and mark the center of the cover Step 3: Position the drain with the silicone gasket under the Step 2: Position the rubber gasket on center of the cover.
Page 3 Step 12: Fold the cover back to expose the bottom of the drain. Step 10: Using a utility knife, Step 11: Take the drain guard and Take the 1” flexible pipe and carefully cut the cover from install it on the reservoir with the two screw the end with the male inside the reservoir and discard.
Page 4 Warranty Information R& R of Mid-America, LLC takes great pride in the quality products we sell. The company maintains high standards for the material and workmanship invested in its products. R&R of Mid-America, LLC warrants its product as follows: R&R of Mid-America, LLC warrants its product to be free of defects in material and workmanship. Should any part of the drain kit body become defective within one year from the date of original purchase.
Page 5 Dryco Pool Cover Drain Kit Important When connecting drain hose to inlet in step 3 of the installation instructions for pool cover, it is extremely important that the hose does not have any loops or kinks in it as shown below in figure 1.
Page 6 Installation Instructions for Pool Cover with Dryco Drain on Above Ground Pools STEP 1: Remove the eyeball diverter from the inlet water return STEP 2: Separate the union that is attached to the hose and screw it in the bulkhead. An adapter will be needed for the bulkhead fittings other than the 1-1/2”...