Fault - Panasonic F-YWP33N Operating Instructions Manual

Fault

Please check the following first.
If the problem persists after taken all these steps, disconnect power plug and call your dealer or
service center.
Error
1
Buttons do not operate.
2
The Full Tank indicator is
flashing even though the
tank is not full.
3
Water is leaking.
4
The tank does not fill up
with water.
(The unit is not
dehumidifying very well.)
5
No water remains inside
the unit.
6
It takes a long time to dry
clothes.
7
Clothes do not dry
completely.
8
The humidity does not
go down.
9
Condensation forms all
the time, even during
dehumidifying.
10
The Check indicator
flashes with error code
[11] displays.
11
Mal-action
12
There is hiss, squeak, or
water flow sound heard
In case of the following, disconnect the power plug and call service center or dealer
Error
13
The "Check" indicator
lights (without flashing)
and prompts error code
(P.7 check)
20
Please ensure its contents
Is the Full tank indicator is flashing (P.14), or is Repair indicator flashing?
(P.7), Key lock Set? (P.19)
Are the tank and float correctly installed inside the unit? (P.14, P.16)
Was the tank banged against the unit during insertion? (P.14)
→ Remove the tank and then reinstall it gently.
Has the unit been tilted or knocked over?
Was the unit moved while there was still water in the tank? (P.4)
Has the float come off? (P.16)
Is the filter clogged (P.17), or is something blocking the air inlet or air outlet?
(P.4)
Are the room temperature and humidity low? (The unit dehumidifies less as
the room temperature and humidity become lower.)
Is the unit set to operate in "Auto" or "Mild" mode? (P.8)
If the temperature is outside the range of 5 ˚C ~ 35 ˚C , dehumidifier
operation will stop and become blower operation. (P.7)
Is the Fan mode set?
→ Fan mode will not retain water.
Is wet, cold air entering the room?
→ Keep doors and windows closed as much as possible while drying clothes.
Did prior clothes drying cycle complete?
Is wet, cold air entering the room?
→ Avoid open doors and windows as much as possible while drying clothes.
Is there a heater in use near the unit?
(If the surrounding temperature is too high, the sensor will be unable to
accurately judge the drying time.)
Is the air blowing onto the all clothes?
Are the clothes hung too closely together or in layers?
Is wet, cold air entering the room?
→ Avoid opening doors and windows while lanundry.
Is there other steam release equipment exists indoor?
It may not be possible for dehumidifying to be fully effective if you place the
dehumidifier in some places such as near windows, or behind furniture
where air circulation is poor.
Is machine body tilting?
→1. Disconnect the plug, lift machine body up straight and wipe waters
leaked
2. leave the machine idle for more than half a day (to dry the unit inside
completely in case any water has spilled inside)
3. connect the plug, run dehumidification again
Is machine body tilted too much?
→ Unplug the power plug and then reconnect it.
Is magnet or metal placed atop the machine? (P.7)
Is the control panel contaminated with foreign matter, droplet, or dust? (P.7)
This is the sound of refrigerant flowing within dehumidifier or nano-ion
generation and is not a failure.
Please ensure its contents
Machine failure, please note down the error code and call service center or
dealer.