James Loudspeakers 101SA-6 Installation Manual

535 Airpark Road, Napa, CA 94558 | Ph: 707.265.6343 Fx: 707.265.6334 | www.jamesloudspeaker.com
10
Attach the finishing trim kit
Fig. 15
There are four trim kits
available to choose from
For Sheet Rock For Solid Surfaces
BACK
ORDER
SA101-5R-SR SA101-4S-SR SA101-5R-W SA101-4S-W
Fig. 17
For 1/2" Drywall omit spacer (a)
For 5/8" Drywall use spacer (b)
If the drywall is in excess of 5/8"
add additional 1/8" spacers
as needed.
11
Install foam dust guard
G
Fig. 20
Recommend testing sub to assure all components
12
are working.
13
Drywall, tape, mud, etc.
Safely store the supplied grille for the final
14
assembly. If you also received the 101SAM-6
module, store this as well.
If you received a 101SAS-6
preconstruction assembly, be sure to order
15
the 101SAM-6 module when ready for
finishing.
Use optional spacer to adjust height
I
P/N SA101-SP-0.125
Fig.t 16
Fig. 18
Fig. 19
63SA-7
Installation
Video
FREQ. RESPONSE
33-150Hz +/-3dB
IMPEDANCE 8 Ohms
SENSITIVITY 87dB @ 2.83V/1M
100-350 Watts
AMP RANGE
RMS POWER 88 Watts
Products suitable for use in
outdoor dry environments
Page 4
101SA-6-INSTALL 140621
101SA-6
Installation guide for the 101SA-6 In-Ceiling Speaker.
Tools Required:
1) #2 Phillips screwdriver
or drill with #2 Phillips
drill bit
2) Straight edge or level
3) Wood or drywall screws
J
4) Allen key (optional)
1
Assemble the parts
I
The brackets (Part No.
SA-BRKT-11-22) are
designed for 16" On-
center constructions,
however can be adjusted
I
I
to accomodate
construction from 11" to
22.5" joist spacing
(Fig. 1).
J
2 Attach the brackets
supplied 8/32 screws
Tighten these screws just enough to allow movement for
adjustment during installation.
Note: brackets can be mounted
to either the sides or the ends of the speaker for added
installation flexibility.
Parts List: Supplied
A
1 - 101SA-6 or 101SAS-6
B
2 - Mounting Brackets
C 4 - 8-32 x 1/2 Pan Head
Machine Screws
D
4 - #8 Lock Washers
E
4 - #8 Flat Washers
F 4 - 6/32 Course Head Screws
G 1 - Foam Dust Guard
B
to the speaker using the
B
, lock washers & flat washers
C D
E
D
C
Fig. 2
Page 1
Parts: Supplied by Installer
H
4 - 1.25" Wood or drywall
screws
Parts: Ordered Separately
I
1 -Trim Ring
J
Spacer Ring(s)
11"
22.5"
Fig. 1
.
E
B
Fig. 3
B
E
D
C
Fig. 4