Table of Contents
Advertisement
local line voltage. Extension cord usage may also affect tool performance.
42.
Welding and cutting operations are a source of radiation, noise, heat, and
noxious fumes. The protection of the operator and any spectators must be guar-
anteed with suitable safety devices and precautions. Never approach arc rays or
hot metal without protection. Failure to observe these standards during operation
could lead to serious health risks.
43.
Use the right tool or attachment for the right job. Do not attempt to force a small
tool or attachment to do the work of a larger industrial tool or attachment. There are
certain applications for which this product was designed. It will do the job better
and more safely at the rate for which it was intended. Do not modify this product,
and do not use this product for a purpose for which it was not intended.
44.
Replacement parts and accessories: When servicing, use only identical replace-
ment parts. Only use accessories intended for use with this product.
45.
WARNING! The brass components of this product contain lead, a chemical
known to the State of Califormia to cause birth defects (or other reproductive harm).
(California Health & Safety code 25249.5, et seq.)
46.
WARNING! This product, when used for welding, cutting, and similar appli-
cations, produces chemicals known to the State of Califormia to cause cancer
and birth defects (or other reproductive harm).
(California Health & Safety code 25249.5, et seq.)
47.
WARNING! People with pacemakers should consult their physician(s) before
using this product. Electromagnetic fields in close proximity to a heart pacemaker
could cause interference to or failure of the pacemaker.
48.
WARNING! The warnings, precautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the operator.
49.
Use eye and breathing protection. Always wear ANSI approved, arc shaded,
impact safety face shield. Always use a full face shield when arc welding. Wear an
ANSI approved dust mask or respirator when working around metal, chemical dusts,
fumes and mists.
SKU 91220
PAGE 10
REV 05/04
Advertisement
Table of Contents
