Table of Contents
Advertisement
Faults and what to do about them
en
Faults
Laundry is not dried cor-
rectly or is still too damp.
Drying time too long?
Displayed drying time
changes during drying
process.
Display panel goes off
and Start button flashes.
Residual water in the
condensation container
despite the dryer being
connected to the con-
densation drain*.
Humidity in the room
increases.
Power cut.
* depending on the model
42
Cause/remedy
After the end of the program, warm laundry feels damper than it actually is.
■
Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 30.
Select a program with a longer drying time or increase the drying level. This
■
does not increase the temperature.
Select a timed program for subsequent drying of laundry that is still damp
■
~ Page 28.
If you have exceeded the maximum load for the program, the laundry may
■
not be dried properly.
Clean the moisture sensor in the drum. The sensor may become covered by
■
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
~ Page 39.
Drying has been interrupted as a result of a power cut, because the conden-
■
sate container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips ~ Page 27.
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
■
ter.
The optimum ambient temperature for drying is between 15 °C and 30 °C.
■
Outside of this range, the drying time may increase.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
The heat exchanger may be dirty and cause a longer drying time. Clean the
■
heat exchanger.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. The dryer recognizes the load and adapts the remaining program
duration.
Not a fault. Energy saving mode is active ~ Page 14.
Not a fault. If the condensation drain is installed, residual water remains in the
condensation container due to the dryer's self-cleaning function.
Not a fault. Make sure the room is sufficiently ventilated.
The drying program is interrupted. Remove the laundry and spread it out, or
restart the program.
Advertisement
Table of Contents
