Summary of Contents for OEM Tools 26100
- Page 1 Air Compressor Manual For questions concerning this air compressor, please call 866-869-3114 Rev: 001 Part# 1312101633...
-
Page 2: Table Of Contents
TABLE OF CONTENTS PAGE Safety Guidelines - Definitions Before Using the Air Compressor When Installing or Moving the Compressor Before Each Use Follow Safety Precautions for Electrical Connection Plan Ahead to Protect Your Eyes, Hands, Face & Ears When Operating Spraying Precautions Perform These Maintenance Operations Typical Compressor Installation... - Page 3 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 Please read and save these instructions. Read through this owner’s manual carefully before using product. Protect yourself and others by observing all safety information, warnings, and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property.
-
Page 4: Before Using The Air Compressor
Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR IMPORTANT SAFETY INSTRUCTIONS WARNING Save these instructions. 19. Be careful when touching the exterior of compressor, pump, motor and air lines; they may Improper operation or maintenance of this product become hot enough to cause injury. -
Page 5: When Operating
Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR SPRAYING PRECAUTIONS WARNING WARNING DO NOT secure compressor with toggle bolts into drywall. Drywall sheeting or plaster will not support the Never point a spray gun at yourself or any other weight of the compressor. - Page 6 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR 5. Always disconnect from power source before GLOSSARY OF TERMS working on or near a motor, or its connected load. AIR FILTER - Porous element contained within a If power disconnect point is out of sight, secure it in the “OFF”...
-
Page 7: Wiring
Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR WIRING DUPLEX WIRING (INSIDE CONTROLLER ON THE BOTTOM) WARNING ALL ELECTRICAL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN GENERAL INFORMATION Adequate wiring and motor protection should be provided for all stationary compressors. - Page 8 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR WIRING Single and Three Phase With Mag Starter 3/17 ™ 2017 OEMTOOLS...
- Page 9 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR WIRING Single and Three Phase Duplex 3/17 ™ 2017 OEMTOOLS...
- Page 10 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR WIRING Single and Three Phase 3/17 ™ 2017 OEMTOOLS...
-
Page 11: Starting The Compressor
Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR STARTING THE COMPRESSOR NOTE: IN SOME INSTANCES, IT STILL MAY BE NECESSARY TO LIFT THE TOGGLE ON THE Prior to actually running the compressor, check the... -
Page 12: B5900
Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR MANUALLY DRAINING AN AIR TANK: WARNING Step 1) Disconnect and lockout the compressor Oil and moisture residue must be drained from the air from the power source (electric models) or receiver daily or after each use. - Page 13 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR TROUBLESHOOTING GUIDE Low discharge pressure 1. Compressor too small for application 1. Reduce air demand or use a compressor with more air capacity. 2. Air leaks 2.
- Page 14 Operating Instructions and Parts Manual 26100, 26101, 26102, 26103, 26104, 26105 and 26106 AIR COMPRESSOR Chicago Pneumatic Full Two-Year Warranty Statement The Company warrants that the Equipment manufactured by it and delivered hereunder shall be free from defects in material and workmanship for a period of twenty four (24) Months from the date of initial start-up, or twenty four (24) Months from the date of shipment from the manufacturer, whichever occurs first.