Fisher-Price BFT59 Instruction Sheet

Troubleshooting
• This toy will enter "sleep mode" after a few
minutes of inactivity. To turn this toy back on, press
a systems or mission button, slide the claw switch,
lift or lower the blaster or fire a disk.
• When movement/sound/lights from Batbot
become slow/faint/stop, it is time for an adult to
change the batteries.
• If Batbot does not respond to the remote control,
it is time for an adult to change the batteries.
• If the remote control or Batbot are accidentally
dropped in the water, remove the batteries
and allow them to air dry. Replace with fresh
batteries before operation.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities.
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifi cations not expressly
approved by the manufacturer responsible for
compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
5